Electronics Forum | Mon Apr 19 01:36:55 EDT 2010 | jola
Been a while since I used those machines but I found a list on how it was on ours anyway: MV2-F,C: F8-F1-F7-SHIFT-M-V MPA-V: F8-F1-F7-SHIFT-M-P-SHIFT-A-SHIFT-V MPA-G1: F8-F4-F7-SHIFT-M-F7-P-F7-SHIFT-A-F7 Always start from the main "run" screen. Go
Electronics Forum | Wed May 31 23:37:37 EDT 2006 | jacksaria
Hello EC, Thank you very much for the good input. I really appreciated. Our mounnters is Panasonic CM402,CM301. Do you have any suggestions/procedure how to reduce the sources of variance at each step of component placement process? regards,
Electronics Forum | Fri Aug 25 08:12:16 EDT 2006 | davef
Leading conveyor manufacturers are ATI, Conveyor Technology, Crown Simplimatic, Dynapace, Flextek, Fuji, Jot, Kanetic, Panasonic, and Process Control.
Electronics Forum | Wed Nov 24 06:24:52 EST 2004 | Joe
Hi, I am an Engineering student doing some research on the component/nozzle interface on SMT Pick and Place machines. Could anyone tell me the force at which the nozzle hits the component as it is picked from the feeder or the placement force on a
Electronics Forum | Sun May 28 23:01:31 EDT 2006 | jacksaria
Hello to all, We are encountered many problems/defects in SMT lines.I would like to know your suggestion or recommendation for SMT optimization and improvement. What are the step by step solutions in order to optimized and to improve the printer, pi
Electronics Forum | Wed Jun 11 11:50:50 EDT 2008 | mmjm_1099
Mydata is a large footprint. I would personally look into AIM, XP242, or even universals or panasonics. I would make sure to watch auctions or check used market. We just purchased a XP242 not long ago from auction for about half the proce of a new on
Electronics Forum | Fri Mar 24 15:20:27 EST 2000 | Chris McDonald
I have recently purchased a Tape and reel machine from V-Tech. We are using Presure Sensitive tape and we are not geting good results. Anything bigger that a SOIC14/16 gives us trouble. The cover tape will pull off on the feeder and we will lose part
Electronics Forum | Tue Mar 04 16:02:53 EST 2003 | Dave C.
We have auto-correct funtion on our Panasonic Create CM-301 placement machines but have never turned it on because of a perceived loss of placement time when the camera verifies placement. We look at the first article and correct placemnt if needed.
Electronics Forum | Wed Aug 13 17:39:27 EDT 2008 | awegener
In light of this new information I've received from everybody's comments, I'd like to get more information about pick and place nozzles. How can I learn more? ... What do the nozzles look like? Are there different shapes? What kind might you r
Electronics Forum | Wed Aug 06 11:16:20 EDT 2014 | clayton
While I have had very limited experience with mancorp, the experience I have had, has been less than satisfactory. However I do have a great deal of experience with Essemtec. I currently own two complete turnkey smt lines from Essemtec and couldn't
