Electronics Forum | Wed Jan 01 13:03:06 EST 2020 | ramsus
hello experts i want to calculate my target of cph i have a panasonic line composed of three machines 1.CM602L 4 HEADS 12 SHAFT 2.CM602L 4 HEADS 12 SHAFT 3. CM602L 2 HEADS 8 SHAFT + 2 HEADS 3 SHAFT Best regards
Electronics Forum | Mon May 21 09:04:15 EDT 2012 | cbeneat
We've had the same issue on our Panasonic CM machines with Cree XP type LEDs. Count on tools makes a urethane tip nozzle that we are using which eliminates the sticking, our concern with these is durability. Nozzle supply company makes a steel Teflo
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
Electronics Forum | Fri Jan 04 16:22:55 EST 2019 | cbeneat
Do you have any experience on CM's? 602/402's in particular.
Electronics Forum | Wed Jul 16 10:08:03 EDT 2008 | tmcarthur
Looking for any information good and bad about the CM602 from Panasonic.
Electronics Forum | Sat Jan 31 13:34:07 EST 2015 | cbeneat
http://industrial.panasonic.com/ww/products_e/product_cat2/AIAH000_e/AIAH000_e/mounter/cm602_e.html... Or google CM602 placement accuracy. http://www.panasonicfa.com/ Good luck
Electronics Forum | Sat Jan 05 04:13:23 EST 2019 | bane016
actually not...only with NPM W2 AND TT2...and with HDP dispenser...CM602 402 is an older generation than NPM but the principle is the same..the program is slightly different...im more than 10yrs in this job..
Electronics Forum | Wed Sep 18 15:41:59 EDT 2013 | cbeneat
For 0402's, if the operator is paying attention, our equipment Panasonic CM 402/602/NPM's run at about .001%. Again this is dependent on an operator that pays attention to the fail rate. We usually don't have too many problems with 0402's, LED's ar
Electronics Forum | Thu May 27 07:04:42 EDT 2010 | dervinsanjose
Anybody who could help me what is the tape peel off speed of PANASONIC CM602 for 8mm feeder? Appreciate your feedback.
Electronics Forum | Sat Feb 11 09:58:20 EST 2012 | cbeneat
I have a question for any Panasonic CM 402/602 users. We run Cree XPE/XPG/XPC LED's on our machines, and have struggled for years with the lights sticking in our nozzles. We have two types, I believe both designed by Cree, one picks the light up by
