Electronics Forum | Wed Jan 01 13:03:06 EST 2020 | ramsus
hello experts i want to calculate my target of cph i have a panasonic line composed of three machines 1.CM602L 4 HEADS 12 SHAFT 2.CM602L 4 HEADS 12 SHAFT 3. CM602L 2 HEADS 8 SHAFT + 2 HEADS 3 SHAFT Best regards
Electronics Forum | Thu Apr 15 10:10:50 EDT 2010 | rmalick
can someone help me with the key strokes to the panasonic mv2 and mpa3 machine secret screen. I know if is shift F7 ??????
Electronics Forum | Fri Mar 20 13:08:53 EST 1998 | BILLIE CHOW
our compant have much fuji machines with low running hours.if anyone interest, email me
Electronics Forum | Mon Apr 19 01:36:55 EDT 2010 | jola
Been a while since I used those machines but I found a list on how it was on ours anyway: MV2-F,C: F8-F1-F7-SHIFT-M-V MPA-V: F8-F1-F7-SHIFT-M-P-SHIFT-A-SHIFT-V MPA-G1: F8-F4-F7-SHIFT-M-F7-P-F7-SHIFT-A-F7 Always start from the main "run" screen. Go
Electronics Forum | Fri Jan 12 15:14:37 EST 2018 | dhollland
Does anyone have any experience with the Panasonic offline recognition machine? If so, thoughts? Would you recommend? Pros and cons? We would be using this with NPM W2 machines...and possibly CM402 machines if possible to use with both.
Electronics Forum | Thu Dec 22 13:36:29 EST 2011 | toddl
Hi all, the company I work for is looking to have our MV series machines calibrated. Is there a service tech available (other than from Panasonic) in the northern US or preferably in Canada able to perform a full calibration? Please send me any feedb
Electronics Forum | Wed May 16 12:29:57 EDT 2007 | realchunks
Hi Pete, I am familiar with their CM series machine. They have anti static bars inside the machine. If I were you I would measure the board after this machine to see if it retains any ESD. If not I don't think you have a problem.
Electronics Forum | Tue Oct 31 19:34:30 EDT 2023 | dilogic
I have considered this solution, but syringe application is very slow and it's hard to control thickness. It's good for partial covering or applying peelable solder mask. We need to coat circular board ca. 10cm in diameter. Takes a while even with sp
Electronics Forum | Wed Jan 03 14:34:43 EST 2007 | buckeyefan
I would have to agree with Pete. I have worked with Panasonic, Create, Mydata and Juki. Juki has been the easiest to work with. They actually installed and had the machines running production within a day.
winsouce.jpg)
