Electronics Forum | Mon Mar 11 07:05:06 EDT 2024 | klauss
while conveyor goes down to relaese pcb, some big compoments are swinging left or right due to high down speed of the conveyor. is there any way to decrease the speed?
Electronics Forum | Wed Sep 18 15:41:59 EDT 2013 | cbeneat
For 0402's, if the operator is paying attention, our equipment Panasonic CM 402/602/NPM's run at about .001%. Again this is dependent on an operator that pays attention to the fail rate. We usually don't have too many problems with 0402's, LED's ar
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
Electronics Forum | Sat Feb 11 09:58:20 EST 2012 | cbeneat
I have a question for any Panasonic CM 402/602 users. We run Cree XPE/XPG/XPC LED's on our machines, and have struggled for years with the lights sticking in our nozzles. We have two types, I believe both designed by Cree, one picks the light up by
Electronics Forum | Sat Jan 05 04:13:23 EST 2019 | bane016
actually not...only with NPM W2 AND TT2...and with HDP dispenser...CM602 402 is an older generation than NPM but the principle is the same..the program is slightly different...im more than 10yrs in this job..
Electronics Forum | Mon Jan 07 16:18:12 EST 2019 | cbeneat
Been working with CM's since 2006, we've had 2 lines of NPM's for the last 4 years. I like the NPM's, but the CM's have been a work horse. We have gotten our monies worth:)
Electronics Forum | Fri Jan 04 05:50:37 EST 2019 | bane016
It's nice to see that you've solved the problem...panasonic npm w2 is very powerfull machine but asks everything to be perfect and everything is pure to work well...looking for a clean ventilated room without dust..regular maintenance daily, weekly,
Electronics Forum | Tue Jan 08 10:16:58 EST 2019 | bane016
Hehe it's nice to hear that you are satisfied with the machine..The only problems with the NPM that we had was filter full for now... Are you using auto changeover,automatic suportpins and material control?
Electronics Forum | Wed May 01 11:47:44 EDT 2024 | linux
Panasonic provide several courses beginners to advance. Not very expensive
Electronics Forum | Fri Jan 04 16:22:55 EST 2019 | cbeneat
Do you have any experience on CM's? 602/402's in particular.
