Electronics Forum | Fri Mar 15 20:56:55 EDT 2013 | marcelorotofrance
At this point all the sensors, switches and solenoid valves were checked. Their electrical signals and actions were phisically checked at the I/O cards level (Panadac 783-065 and 065A). Above mentioned signals were monitored from "I/O Monitor" functi
Electronics Forum | Wed Mar 27 16:03:01 EDT 2019 | jdengler
Jim, It's been a long time since I worked on one of these so this is going to be a general idea as to the issue. There's a solenoid valve that is controlled by the E-stop ckt. When in E-stop in stops air from entering and vents the pressure lines
Electronics Forum | Mon Apr 10 15:34:53 EDT 2017 | mrich208
Hey Jerry, The valve that sends air to the head of the inserter does not close when you press the "Interlock" button. If you press on the end of the solenoid with a screewdriver to force it the air makes it to the head. If doesn't seem like it is tr
Electronics Forum | Mon Apr 10 14:26:38 EDT 2017 | jdengler
Hi Mark, The status messages for these older UIC machines aren't always as helpful as we would like them to be. What exactly is happening? No air for the whole inserter part of the machine, or the inserter head only? It's been a while since I ha
Electronics Forum | Thu May 20 22:38:01 EDT 2021 | kumarb
For closure to all readers of this thread...many thanks to Michal for this support. Trans-tec (USA) was great in replying to our countless emails on this topic. We sourced a replacement solenoid # A041E1-48W for our Emerald-X = YV88X. The part was a
Electronics Forum | Wed May 19 20:24:09 EDT 2021 | kumarb
Thank you Michal. Very much appreciated. We are thinking along the same lines. However, we are being very afraid to even cut the official wire ties that are securing the head 1 and head 2 wiring. We have a new VAC2 solenoid in transit that will arr
Electronics Forum | Tue Nov 01 09:24:06 EST 2005 | UIC HSP Techs
The problem you report is very uncommon. Nozzles falling out of the placement heads can only be caused by severe mis-adjustment or failed parts. The following items should be checked: 1) Nozzle position hooks (on placement heads) 2) Clutch solenoid/
Electronics Forum | Wed Mar 13 11:03:59 EDT 2013 | marcelorotofrance
Despite this machine is an obsolete dynosaur, almost 1/4 century old, is (was) a reliable work horse. Now is broken. Just after first reset the screen shows an error message "1420 XY INTERLOCK". The message clears with RESET. When I push ORG button
Electronics Forum | Fri Jan 08 06:14:32 EST 2016 | bobpan
There should be a regulator to adjust the puff off on the inside left back panel. Remove the left side cover to get to it. Write down what its set at prior to adjusting it. I have also seen this problem caused by water in the system. Make sure that y
Electronics Forum | Wed May 19 20:11:21 EDT 2021 | compit
I have two machines - Emerald-X and Topaz-X. I cleaned (and changed Koganei electromagnets) only in Topaz-X - Emerald-X is in very good condition :) But my Emerald-X have SF (not FNC) heads. If head 1 is OK - change the relays with head 2 and check.
