104 panasonic motor driver results

Electronics Forum: panasonic motor driver (Page 3 of 11)

zevatech 730 help

Electronics Forum | Sat Mar 04 11:07:21 EST 2006 | charls

hi pavel, If you are getting vibrate during fast mode, encoder or motor cable might be faulty. yes i faced the same problem in Juki KE2010 m/c. Try by replacing encoder & motor cable from Motor to driver unit. All the best

MPM UP2000 alarm

Electronics Forum | Wed Oct 20 03:56:19 EDT 2010 | michaellaw

Hi, Some idea for you to troubleshoot: *It could be the motor problem,check all motor power,after ON power to m/c,the motor should be engaged. *stepping driver spoil

Panasonic servodrivers in Tenryu

Electronics Forum | Sun Mar 31 07:43:32 EDT 2013 | lkavan

Thank you very much, you are an angel, DOS software works with these drivers! But some servos still shaking and I cannot tune it by decreasing the gain or autotuning :-( Problem is with driver, when I change it servo works well. All drivers have the

4C will not home

Electronics Forum | Tue Jan 13 08:08:37 EST 2009 | leemeyer

I am assuming that the card that was changed was the motor driver card. Did they change the card with a known good board or just swap the X and Y cards. If they swapped cards it appears that the card that is now in the X motor slot is bad. Open the a

MPAV Y-Axis deviation overflow

Electronics Forum | Mon Nov 17 00:13:46 EST 2003 | shawn

if george idea doesn't solve ur problem then it must either be the driver or the y-axis motor itself.try swaping the driver with other machines if u can afford it . good luck.keep me posted of the developments.

Troubleshooting a Panasonic Screen Printer

Electronics Forum | Tue Aug 26 15:05:59 EDT 2003 | Robert H.

Hi, Does any one know why on the Panasonic Screen Printer machine SPP(LL) the Motor Drive Panadac-321-5 turns on the light ST? I already try another Motor Drive and it does the same. Thank you.

MPA-V

Electronics Forum | Mon Sep 26 18:46:37 EDT 2005 | stano

Hello. We have problem with MPA-V. Problem is with V1, V2 axis. Error is V1 AXIS MOVEMENT IMPOSSIBLE and V2 AXIS MOVEMENT IMPOSSIBLE. On the driver for this axis lighting error LED ST (sensor touble). It is problem in connection between motor encoder