Electronics Forum | Mon Jul 26 21:56:53 EDT 2004 | pdeuel
The camera is not driven from the motor cards. The camera is attached to what is called a forcer. For the Y axis there are two of them. One is wired backwards from the other. one of the forcers is connected to a flex chanell for the air and electrica
Electronics Forum | Fri Mar 04 18:06:23 EST 2005 | alandra516
Having problems with a error (7x motor driver error) which happens everytime we turn on the 84VZ. Anybody out there had experiance with this is the past? Can you steer me in the right direction?
Electronics Forum | Mon Oct 02 17:00:13 EDT 2006 | Chris G.
Does anyone have a motor frequency inverter(driver) for an ERSA Versaflow, that you can sell me? It says "Seidel" and then "digifas 7200". I know this is a long shot, but even if it's used I'll take it.
Electronics Forum | Tue Jan 13 09:50:36 EST 2009 | leemeyer
They also need to make sure that the switch settings are correct when changing cards. Each motor driver card has a different switch configuration depending on which slot it is installed in.
Electronics Forum | Thu Apr 09 10:34:10 EDT 2009 | chrisgriffin
The Z axis is overloading. Could be a connector between the top of the table and the bottom of the rails, or a faulty motor, z-brake, or driver. Good luck!
Electronics Forum | Thu Sep 20 21:58:39 EDT 2012 | jeffr
4 connectors because the pins push back ! 2/.. Check mechanical freedom of each axis. With power off.. feel each motor rotation for a burnt armature. 3/.. Replace the Driver Board.
Electronics Forum | Wed Oct 12 10:57:18 EDT 2016 | dekhead
Could certainly be sensors; does table (attempt to?) move out upon machine initialization? Or could be bridge driver (on board) or motor. JOHN www.dekhead.com
Electronics Forum | Wed Jul 03 07:49:35 EDT 2019 | daniel_marquette
Got it. Servo tuning is new to us, so we'll try it. When you propose to swap the Y axis amps, do you refer to the driver that controls the Y motors? Thanks,
Electronics Forum | Fri Oct 27 21:39:48 EDT 2023 | sarason
Stepper motor drivers from Analog Devices? Send an email to Analog Devices and talk to a rep or go on the EEVBlog Forum and ask in https://www.eevblog.com/forum/beginners/ or https://www.eevblog.com/forum/projects/ regards sarason
Electronics Forum | Tue Nov 25 18:39:59 EST 2014 | rhcriad
We have an MPM UP2000 stencil printer and have a lot of issues with burned out 6410 driver cards (or driver cards just failing to work). I have looked over these threads and found that this is a common issue with these cards. I understand that thes