Electronics Forum | Thu Nov 11 17:49:11 EST 2004 | pdeuel
We are having a problem with our AP-24x printer. When the vacuum motor spins up we get a 60 hz buzz into the DC drivers for the forcers and the stencle wiper. We also indicate a main power drop from 115 vac to 80 vac. The vacuum motor checks out good
Electronics Forum | Mon Oct 11 17:06:55 EDT 2004 | M Deren
We have a DEK 260 with a intermittent table align stepper motor problem. The machine will work fine for awhile and then one of the table align motors starts either moving haphazardly in small increments back and forth or vibrates as if it wants to mo
Electronics Forum | Thu Sep 24 00:52:41 EDT 2015 | ermani9
Hi.. Move the XY arm to the center of the machine. Turn on the servo then immediately hold “LOWER” then press “ORIGIN”. You should see the message now on the screen “DRIFT CHECK”. The arm will start to drift without an emergency condition occurr
Electronics Forum | Sat May 14 12:28:49 EDT 2016 | dilogic
Any ideas that can cause y-axis resonance? I ruled out all usual the suspects (tacho sensor, driver cards, motor driver etc.). Looks like some mechanical issue, but can't figure it out. I suspect leadscrew nut - I checked it with motion diagnostics s
Electronics Forum | Sun Mar 26 12:04:41 EST 2006 | fastek
Mike- Send me the part number from the manual. I carry a lot of PFA spares. If this motor is used on other PFA models I might have it....but I need more info. If you don't have the manual then forward the detail from the motor itself and send me a
Electronics Forum | Wed Nov 02 16:35:20 EDT 2016 | csm
Dear FUJI Specialist, I need your HELP, we have an CP8-42-E and machine was working properly and from one day to another when we Turn ON the machine make all the startup and check all the list, when all is ready, you have to Puch Ready and automaticl
Electronics Forum | Wed Apr 24 14:14:57 EDT 2002 | stefwitt
If nobody else can help you and you are not afraid to add a bit of hardware, I would like to give it a try. If pistons are air activated there should be a solenoid for each piston. Locate the I/O signals, wire in a double through switch and apply 24
Electronics Forum | Mon Oct 11 17:02:06 EDT 2004 | M Deren
We have a DEK 260 with a intermittant table align stepper motor problem. The machine will work fine for awhile and then one of the table align motors starts either moving hapazardly in small increments back and forth or vibrates as if it wants to mov
Electronics Forum | Wed Feb 04 23:27:38 EST 2004 | dougt
I did some work with 400E's and have can give you a couple things to try with your Y axis problem. 1. There is a file called stepperparms.exe that will load all the stepper parameters on the PCL IC's. Your y axix chip may have corrupt data on it.
Electronics Forum | Tue Nov 01 09:36:41 EDT 2011 | emeto
THe question is - does that happen on all of your programs or just in one program? If it is just this particular board, it might be some softwaRE limit issue. If it happens on more programs it is a hardware issue and it could be one of the following:
