Electronics Forum | Mon Apr 19 01:36:55 EDT 2010 | jola
Been a while since I used those machines but I found a list on how it was on ours anyway: MV2-F,C: F8-F1-F7-SHIFT-M-V MPA-V: F8-F1-F7-SHIFT-M-P-SHIFT-A-SHIFT-V MPA-G1: F8-F4-F7-SHIFT-M-F7-P-F7-SHIFT-A-F7 Always start from the main "run" screen. Go
Electronics Forum | Mon Mar 05 15:56:21 EST 2007 | jasont
NM-2858 is European style M size MV2F. NM-2859 is European style XL size MV2F. MV2F is manufactured rated at 0.1sec per placement however, I have only seen them acheive around 20-25,000 cph I have x2 MV2F-XL "Q" in stock (NM-2559MB) w/feeders. IF
Electronics Forum | Fri Mar 11 16:21:23 EST 2005 | George
What "initial settings" need to be turned on for Panasonic MV2F to start sending data to the data port? Thanx
Electronics Forum | Fri Sep 01 10:12:04 EDT 2000 | Anderson L. R. S�
We get problem with our PANADAC 945A-D board of MV2F machine and and we are trying to find some company that have the same board to replace it or fix it with urgency. Please, contact me by e-mail: anderson.sa@edb.ericsson.se Thanks!
Electronics Forum | Fri Sep 24 22:43:07 EDT 2004 | FengAng
Hi Rob, We use the most advanced equipments in front end, but the back end we always use manual assembly, including display, LCD, casing. It's all because we should balance the cost & efficiency. I think if you are the boss, you will also do thing
Electronics Forum | Thu Sep 14 21:39:18 EDT 2000 | Rick Flayler
I'm trying to locate and purchase one or two Panasonic lines configured as follows: MV2F (LL) or (XL) size. Prefer "K" style with feeders. MPA-V (XL) size. Rick Flayler- Fastek www.fastek-smt.com
Electronics Forum | Tue Sep 15 19:23:18 EDT 1998 | Jimmy Strain
| I am thinking of purchasing a Panasonic MV series chipshooter. If you own a Panasonic MV machine I would like to hear what you like and dislike about it. Is the service good? Are spare parts readily availiable? Does Panasonic support and follow up
Electronics Forum | Thu May 21 18:19:38 EDT 2020 | ccouture
here is how to access the secret screen: MV2-F,C: F8-F1-F7-SHIFT-M-V found it after googleing it. Hope it helps.
Electronics Forum | Thu Apr 28 15:56:44 EDT 2005 | stepheniii
Hopefully it is just the part data a little bit off. But if that doesn't help, make sure the thickness sensor is calibrated bang on. And do the nozzle height adjustment. What are your nozzles and filters like, as far as being clean goes? I've put dow
Electronics Forum | Wed Mar 08 23:40:43 EST 2006 | fastek
If......... 1) Assuming you are panelizing them (you would have to actually).... 2) You don't have any fine pitch parts on the board then I would suggest a chipshooter like a Fuji CP-6 or a Panasonic MV2F. Get (2) of these used for around $100K ea