Electronics Forum | Mon Mar 11 07:05:06 EDT 2024 | klauss
while conveyor goes down to relaese pcb, some big compoments are swinging left or right due to high down speed of the conveyor. is there any way to decrease the speed?
Electronics Forum | Thu Oct 14 08:14:36 EDT 2010 | rway
We use both Panasonic and JOT. JOTs are a good conveyor. The Panasonics will probably cost you less. Check the used equipment market. That's where we got all of ours and I haven't had any issues with any of them except the normal where and tear o
Electronics Forum | Fri Apr 07 05:10:29 EDT 2023 | abhishek10
Reverse Polarity Defect in diode.what could be the reason and how to avoid it. We have the issue facing in NPM and CM machines of panasonic.Any investigation would help.
Electronics Forum | Wed Nov 14 16:03:08 EST 2018 | cbeneat
Wondering if anyone will have an idea on what we are experiencing with our Panasonic. When the machine goes to change nozzles,it errors out saying "Nozzle exist error(Rack) occurred,(R side)" There is nothing in the nozzle bank, actually replaced ban
Electronics Forum | Thu Jan 03 15:53:28 EST 2019 | cbeneat
We did figure out the issue. The plastic cover inside the LED lighting unit had a slight film covering it, which made the picture slightly hazy. We had to disassemble the LED module to get at it, cleaned it and it was fine. I didn't think this would
Electronics Forum | Wed Jul 12 17:17:04 EDT 2006 | fordf1502004
I want to thank you for your help. after further investigation into the panasonic machine one our technicians was able to fix the issue. The panasonic machine uses a 5 volt signal and normal smema uses a 24 volt signal. To make these 2 machine talk t
1 |