Electronics Forum | Mon Mar 11 07:05:06 EDT 2024 | klauss
while conveyor goes down to relaese pcb, some big compoments are swinging left or right due to high down speed of the conveyor. is there any way to decrease the speed?
Electronics Forum | Wed Oct 29 10:36:33 EDT 2014 | blainemoran
Looking for a maintenance mode on the NPM-W where I can isolate and fire different components. For example if I suspected a bad motor is there a way to just attempt to fire that. Any advise?
Electronics Forum | Wed Oct 29 18:08:35 EDT 2014 | tombstonesmt
Good afternoon. Not sure if this is available at an engineer level. Perhaps and SD card with field service access is necessary. We have two lines with NPM-W's and the most we've been able to do is actuate vacuum on the heads during flow checks.
Electronics Forum | Fri Jan 04 05:50:37 EST 2019 | bane016
It's nice to see that you've solved the problem...panasonic npm w2 is very powerfull machine but asks everything to be perfect and everything is pure to work well...looking for a clean ventilated room without dust..regular maintenance daily, weekly,
Electronics Forum | Tue Jan 08 16:12:57 EST 2019 | cbeneat
We are using material control, and our auto support pins are from Quik Tool. They integrated there modules into our machines, we're happy with it. Not using auto changeover as far as I know, I stick to the maintenance side. We have a programmer that
Electronics Forum | Sat Jan 05 04:13:23 EST 2019 | bane016
actually not...only with NPM W2 AND TT2...and with HDP dispenser...CM602 402 is an older generation than NPM but the principle is the same..the program is slightly different...im more than 10yrs in this job..
Electronics Forum | Mon Jan 07 16:18:12 EST 2019 | cbeneat
Been working with CM's since 2006, we've had 2 lines of NPM's for the last 4 years. I like the NPM's, but the CM's have been a work horse. We have gotten our monies worth:)
Electronics Forum | Tue Jan 08 10:16:58 EST 2019 | bane016
Hehe it's nice to hear that you are satisfied with the machine..The only problems with the NPM that we had was filter full for now... Are you using auto changeover,automatic suportpins and material control?
Electronics Forum | Wed May 01 11:47:44 EDT 2024 | linux
Panasonic provide several courses beginners to advance. Not very expensive
Electronics Forum | Fri Jan 04 16:22:55 EST 2019 | cbeneat
Do you have any experience on CM's? 602/402's in particular.
