Electronics Forum | Tue Mar 10 19:04:16 EST 1998 | William Kelley
| Where I can buy the used Fuji or panasonic SMT line? My name is William Kelley and I am the customer service manager for Circuits Inc., we Install equipment for GE Capital which supplies used refurbished equipment nation wide. I dont know what area
Electronics Forum | Mon Mar 09 16:09:38 EST 1998 | Dave Celestian
Check out some of the brokers on the internet. Look under "Used PCB Assembly Equipment". "Fastex" is one of the companies that sells used equip. There are quite a few. Make sure you get a warranty with whoever you pick...
Electronics Forum | Fri Mar 20 13:08:53 EST 1998 | BILLIE CHOW
our compant have much fuji machines with low running hours.if anyone interest, email me
Electronics Forum | Mon Mar 11 07:05:06 EDT 2024 | klauss
while conveyor goes down to relaese pcb, some big compoments are swinging left or right due to high down speed of the conveyor. is there any way to decrease the speed?
Electronics Forum | Fri Dec 21 18:44:23 EST 2018 | ramsus
hello I chose to change the wet cleaning paper and dry paper with wet cleaning mode activation but I have a solvent leakage problem (solvent leak alarm) I detected a leak at the level of cleaner. can you get an idea about this problem and can help m
Electronics Forum | Mon Apr 19 01:36:55 EDT 2010 | jola
Been a while since I used those machines but I found a list on how it was on ours anyway: MV2-F,C: F8-F1-F7-SHIFT-M-V MPA-V: F8-F1-F7-SHIFT-M-P-SHIFT-A-SHIFT-V MPA-G1: F8-F4-F7-SHIFT-M-F7-P-F7-SHIFT-A-F7 Always start from the main "run" screen. Go
Electronics Forum | Wed May 29 02:01:10 EDT 2024 | kumarb
No direct experience with these parts but to me, the air flow from top side fans are creating a wind tunnel that is causing the smaller parts to fly. Can you adjust the speed of these fans? Review the paste - review the component mount height. We fac
Electronics Forum | Wed May 29 07:41:33 EDT 2024 | tommy_magyar
We use the same component on many different products, never faced a similar issue. However, things I would check are: - stencil thickness (ideally 125um) - additional Z move on the parts around the relay (as suggested by kumarb) - check the packages
Electronics Forum | Thu Oct 02 13:59:34 EDT 2003 | Gabriele
Both CM202DS/CM402 (Create) and Topaz (Yamaka) are reliable Jap equipment. CM402L will have a great future. Regards, Gabriele
Electronics Forum | Thu Oct 02 08:29:55 EDT 2003 | serial_killer
Thanks for the input!