Electronics Forum | Mon Jun 06 10:43:23 EDT 2005 | ratsalad
Hello there, We have a Panasonic MVIIC with a bad PCB camera. The amp is fine, we tested that by swapping it with the small and large parts camera. When the machine is shut down for a while and we bring it back up, it takes hours for the PCB camer
Electronics Forum | Tue Oct 31 23:46:12 EST 2006 | fastek
Which nozzles are coming up NG on the large camera? If it's the smaller ones, don't worry about it. Those nozzles don't use the large camera anyways. Be concerned if the small nozzles are coming out NG on the small camera.
Electronics Forum | Tue Oct 31 19:42:11 EST 2006 | dg
We have a Panasonic MV2V machine with orange reflectors. When the nozzle centre measurement is run, many of the nozzles have a blue NG for the large camera. We have tried adjusting the spotlight positions, cleaning and/or replacing reflectors, replac
Electronics Forum | Mon Jun 06 11:56:45 EDT 2005 | ratsalad
Thanks for the leads. They both said they might have one and they are checking into it. I was right the first time! All three cameras are the same. It was the Panasonic help desk that told me they were not. Checking in the manual shows all three
Electronics Forum | Wed Nov 14 16:03:08 EST 2018 | cbeneat
Wondering if anyone will have an idea on what we are experiencing with our Panasonic. When the machine goes to change nozzles,it errors out saying "Nozzle exist error(Rack) occurred,(R side)" There is nothing in the nozzle bank, actually replaced ban
Electronics Forum | Fri Sep 20 15:44:00 EDT 2002 | pjc
Do you have a Panasonic & Toshiba camera? What are the MPM p/ns your looking at? Whats the problem? Noise perhaps. If noise try checking the metal cylinder to the right of the camara housing. The set screws can loosen up. Tighten up all the screws.
Electronics Forum | Mon Jun 06 10:52:15 EDT 2005 | cmiller
Try Rick at FASTEK 925-371-6000 He is in California and seems to do more panasonic stuff than anyone else. I have bought and sold stuff from/to him, he is a good guy. Maybe also CE-Exchange.
Electronics Forum | Sat Mar 25 16:01:08 EST 2006 | gipos
Dear all, Please help me to find out where we can find a Z axis camera motor for Panasert SPP A- M (NM 2624F)paste printer ?? Thank you Mike ZIG
Electronics Forum | Fri Mar 02 16:06:36 EST 2007 | peterson
Mydata machines are very solid. They are always upgradable since the base machine is essentially the same. Recent advancements in camera and feeders have increase placement speed. However, this is generally not the machine you would select and expect
Electronics Forum | Wed Oct 08 10:54:35 EDT 2008 | stepheniii
Check with your stencil house. At one time I used a Panasonic screen printer with the fiducial camera looking at the top of the stencil. The stencils are cut from the bottom so the fiducials had to be cut all the way through. And the stenicl house wo
winsouce.jpg)