Electronics Forum | Wed May 09 11:59:50 EDT 2012 | aemtexas
Our Panasonic KME Create CM95R-M pick and place machine was in storage for a long time and the system battery died, so now the static RAM is corrupted. We need to obtain a "key" floppy to reflash the static RAM. Thank you in advance for any advice an
Electronics Forum | Fri May 16 03:37:04 EDT 2008 | ianlg
Hi There is a Benchtest on the EPP Stand at the SMT Hybrid & Packaging exhibition that may be on interest to you where 11 printers are going to be tested against each other. It should be interesting to all who are looking to purchase a screen printe
Electronics Forum | Wed Sep 15 19:01:39 EDT 1999 | DGrenier
| | I'm hoping to use 0201 caps and resistors in a new design but so far have only found one company who makes such small devices (Murato). | | | | Can anyone direct me to any other supplier? | | | | Are there any particular problems associated wi
Electronics Forum | Wed Nov 14 16:03:08 EST 2018 | cbeneat
Wondering if anyone will have an idea on what we are experiencing with our Panasonic. When the machine goes to change nozzles,it errors out saying "Nozzle exist error(Rack) occurred,(R side)" There is nothing in the nozzle bank, actually replaced ban
Electronics Forum | Mon Aug 23 14:49:36 EDT 2004 | msjohnston1
I have no experience working with the systems you listed about, however I have experience working with a GSI Lumonics SVS systems measuring solder paste. I am also in the process in looking for new equipment to replace the GSI systems that is capabl
Electronics Forum | Wed Jan 03 15:15:43 EST 2007 | John S.
I've worked with Juki and Panasonic/Create. Both have been good machines, but we've found Juki to be superior in cost, performance, and service. Our 750's are 8 years old and still run great. We've just gotten a 2060R this last year, and we've rea
Electronics Forum | Sun Dec 25 18:54:04 EST 2005 | mariss
We are experiencing fracture problems with 0805 X7R capacitors. The capacitors seem to fail in tension; during hot-air rework they come apart in two pieces with the fracture near the metallization end. Only X7R SMT components are affected, C0G and Y
Electronics Forum | Fri Aug 24 04:58:54 EDT 2007 | gsala
Thank you Davef, by googling 2512 R (plus Lead Free) I found plenty of interesting informations about the subject. What I have seen 2512 R is one of the "hot" smd chip resistor used for several Reliability Test Vehicles or Trials. Seen also availa
Electronics Forum | Fri Jul 09 19:09:52 EDT 2010 | rway
A couple of things: Does the cap break if you try to remove it with hot air? If not, than you are breaking the caps do to mechanical stress. We have had similar issues. I don't think your board is suffering from mechanical stress from depaneling o
Electronics Forum | Fri Jul 28 11:12:18 EDT 2023 | shrikant_borkar
Hi SimionR, Is Glue Process Dispencing or Glue Printing thru Stencil? if Its Dispencing Glue thru a Nozzle then its a controllable process. I have performed it thru HDP-3 Panasonic. Placement of Glue either one DOT or Process must be aligned with th
