Electronics Forum | Tue Apr 07 09:35:29 EDT 1998 | Chris Jackson
I am looking for suppliers of SMT setup verification systems that use bar code lables as the medium. I have located Brady and Unicam's verifeed. We have immediate need due to the push to remove component markings. We have two lines presently: Panason
Electronics Forum | Fri Apr 17 19:40:16 EDT 1998 | M. Faisal Pandit
| I am looking for suppliers of SMT setup verification | systems that use bar code lables as the medium. | I have located Brady and Unicam's verifeed. We have | immediate need due to the push to remove component | markings. We have two lines presentl
Electronics Forum | Fri Apr 24 15:28:06 EDT 1998 | joe devaney
| I am looking for suppliers of SMT setup verification | systems that use bar code lables as the medium. | I have located Brady and Unicam's verifeed. We have | immediate need due to the push to remove component | markings. We have two lines presentl
Electronics Forum | Wed Nov 17 09:51:25 EST 2004 | AS
I'm looking for advise on setting up a prototype station for smt (we are currently outsourcing smt production, but have a need for rapid in house prototyping). The station must be able to handle only single sided boards with components no smaller th
Electronics Forum | Tue Sep 15 16:37:26 EDT 1998 | Earl Moon
| I am thinking of purchasing a Panasonic MV series chipshooter. If you own a Panasonic MV machine I would like to hear what you like and dislike about it. Is the service good? Are spare parts readily availiable? Does Panasonic support and follow up
Electronics Forum | Fri May 11 16:06:49 EDT 2001 | Charlie
How to solder one zero ohm 0805 resistor to a PCB after it is mounted in it's plastic. The Panasonic "Soft Beam" would do it if money were not a factor. Is there a similar type of soldering station out there that may just bolt to an existing conveyor
Electronics Forum | Wed Jun 24 07:01:12 EDT 2015 | beta
Hi all, I am looking for some info on these machines and in particular if they can be programmed at the machine as a stand alone or do you need an external programming station. If anyone has any programming manuals soft copies that they can share,
Electronics Forum | Wed Feb 02 16:29:43 EST 2011 | remullis
I can explain our kitting process which was heavily software managed. For our Chipshooters we grouped setups of the optimum algorithym for less carriage movement, and grouping part numbers as much as possible. This was done with some high dollar sof
Electronics Forum | Wed May 26 04:46:13 EDT 2010 | mmjm_1099
ALl - I need some feedback why a solenoid on station 3 is getting excessively hot. I have another line with the same setup but is not getting as hot. I have tested out voltage and see nothing that is triggering me there is an overvoltage. Any feedbac
Electronics Forum | Fri Jun 03 09:23:48 EDT 2016 | designhaus
Thank you for the great feedback. We're definitely taking all of these into consideration. Currently, we're shooting for the following: - JTAG Testing setup - Rework station - A hot air rework station - A quality microscope/vision system Have
