Electronics Forum | Fri Jun 16 00:45:19 EDT 2006 | Richard Robins-Bird
Not all splicing tapes require the use of specialist tooling or splicing plates to make a join. Please see wwww.fujismt.com where a complete range of SMT splicing tapes (Joint Tapes) can be found for use with chip mounters such as Assembleon, Europla
Electronics Forum | Sun May 05 10:36:08 EDT 2013 | mbb
Hello, We are using Panasonic pick and place machine. I would ask if there is anyone from Panasonic to tell us which is the tape splicing method the most adequate to Panasonic feeders?
Electronics Forum | Mon May 06 07:22:23 EDT 2013 | cbeneat
Do you have the splice manual? I can email you a copy, send your email address to me I will send it out.
Electronics Forum | Mon May 06 09:01:08 EDT 2013 | mbb
Yes, we have manual splice either with a joint tape or with both clips and joint tape . Please, If you have any suggestions, email me on: mariem.khlifi@ymail.com
Electronics Forum | Tue Sep 17 05:19:48 EDT 2013 | engineering@smtxtra.com
Hello, its simple the Panasonic tape is encoded, the non original splice tape you try to replace is not coded hence error on feeder sensor. we offer Panasonic replacement splice tape, for a sample please contact the office, hope this helps Robi SmtXt
Electronics Forum | Sun May 08 23:47:09 EDT 2005 | vera1001
hi Infinity: i think the splicing tape is useful to you maybe,such as double splice tape,four splice tape,splice tape for panasonic,splice tape for simens and so on. i come from china,maybe you will visit http://www.comofaje.com and looking for the p
Electronics Forum | Mon Sep 16 18:45:26 EDT 2013 | mbb
Hello, We have currently Pick and place machine (Panasonic) with tape splicing joint sensor,the issue is, that once we want to change tape splicing for costs reason, the sensors don't detect any tape splicing .Is there anyone from Panasonic to expl
Electronics Forum | Thu Jun 20 12:56:21 EDT 2013 | cbeneat
We've only used/seen the manual splicer. However our operators can splice a part in 30-45 seconds. What Panasonic models do you use? The CM/NPM's give you plenty of warning that a splice is needed so the machine doesn't stop.
Electronics Forum | Sun Jun 16 15:14:55 EDT 2013 | mbb
Hello, We are using Panasonic as pick and place Machine with joint detection mechanism. Operators are spending so much time in splicing operations. I would like to know if there is any tool or machine to do automatically splicing (with less time spen
Electronics Forum | Wed Sep 25 12:42:30 EDT 2013 | Chris
You have to make sure the tape is covering the holes, this is where the sensor reads the tape.
winsouce.jpg)