Electronics Forum | Thu Apr 28 08:04:45 EDT 2005 | stepheniii
I like Mydata, Fuji, and Panasonic equipment. However if you have one, I"m not a fan of mixing. I have worked with the IP3 with MTU. I found it a good solid machine. The only thing at that time was the programing. I believe they have changed thi
Electronics Forum | Fri Aug 19 15:45:45 EDT 2005 | DannyJ
I usually like to have all the trays use pin 1 in a certain direction. In other words, as you are on the operating side of the machine, all the pin 1's should be on the lower left of the tray. With operators, the KISS principle seems to be necessar
Electronics Forum | Fri May 17 09:41:39 EDT 2002 | pteerink
Save your money. I tried to buy one for a G3 before, had one actually shipped in, and had to return it because it didn't fit the machine. Some other options: 1) buy a tape and reel machine cost you about $10K, but then you have control over
Electronics Forum | Thu Sep 19 14:25:30 EDT 2002 | stepheno
Changing the pitch on the newer feeders is a little bit different and involves adjusting the location of a sensor. Where we lose the parts is at change-over. There are some reels that we might put on and take off a feeder 20 times before the reel is
Electronics Forum | Wed Sep 27 17:06:26 EDT 2006 | daxman
Hey Guys, I checked the histogram...it doesn't look good. I'm assuming the graph for the black bars has to be in the green on the left and the graph for the white card needs to be in the green on the right?? Anyways, I can't find a "GS4 pot" I looke
Electronics Forum | Wed Dec 09 17:22:09 EST 2015 | tombstonesmt
I couldn't be more pleased with Panasonic. We've upgraded from MPAV's and MSR's to CM602/DT401 and now their NPM platform. NPM's are extremely fast and accurate. Their auto pickup position teach is great especially if you're running any 0402 2mm pit
Electronics Forum | Fri May 27 14:15:21 EDT 2005 | ve7khz
Hi Folks, Starting a second SMT line this year and it's been (too) long since I have looked at newish machines and I am in need of some assistance with P&P machine selection. Here is what we currently have: Panasonic CM-202 chip shooter 216 8mm reel
Electronics Forum | Mon Feb 25 18:10:13 EST 2002 | stepheno
When you say "dropping" I assume you mean "rejecting" them because co-planarity is outside the tolerance you have set and the machine is putting them on the reject belt or tray as the case may be. I worked for a CM with an MPA-G3. One customer suppl
Electronics Forum | Tue Sep 03 09:57:05 EDT 2024 | poly
What other machines have they got? I've got a gc30, gx37 and gc11. The lightning head has a much more limited height range than the 7 spindle or 4 spindle heads. You can't pick off trays with the lightning either. The GC60 / GC120 are amazing for
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
