Electronics Forum | Tue May 08 09:50:19 EDT 2007 | patrickbruneel
Hi Loco, Good point!! The good old glass plate works just fine as long as the conveyor or carriers have L shaped fingers. A glass plate is usually about a � inch thick (a lot thicker than the actual board). With L shaped fingers the bottom of the gl
Electronics Forum | Wed Aug 23 02:48:11 EDT 2006 | ec
Hi, Appreciate someone could advise or forward a format to me how to work out number of pallet needed for wave-solder if the machine speed is at 1.0m/min, volume per month is 4500 sets, pallet length 0.3 meter, conveyor length 5 meter...... Looking
Electronics Forum | Sat Feb 05 09:13:39 EST 2000 | Dave F
Hany: In response to your questions: 1- In a double wave solder M/C, is possible to completely eliminate the second wave without affecting the quality of the solder joints? Many w/s machines have a turbulent wave and a smooth wave. The turbule
Electronics Forum | Wed Oct 11 22:23:39 EDT 2006 | billwestiet
I've installed a number of these machines here in the US, several of them with VOC free applications. I would need to get a bunch of questions answered before I could make any suggestions: What is the pcb width? length? conveyor speed? flow rate (mm
Electronics Forum | Mon Jun 25 20:59:51 EDT 2001 | davef
As Wolfgang says: Conveyor speed may be too high. Excuse me for not stripping-out my repetition from your list, but other machine adjustments to consider are: * Using more efficient [higher specific gravity] flux. [Got it!!!] * Adjusting wave shape
Electronics Forum | Tue Dec 16 06:42:51 EST 2003 | Kev
I am having problems achieving correct pre-heater temperatures with our Hollis solder wave. Our original "Verification Golden board" program uses a conveyor speed of 5ft per minute and pre-heat temps of 300, 350, 400 respectively. Our "golden Board"
Electronics Forum | Thu Nov 08 16:02:28 EST 2007 | ck_the_flip
We've got lots of connectors at my place of employment like this. What I do is... I run these "slower than molasses in January" - we're talkin' 2 Ft/Min. conveyor speeds. Obviously this will have an effect on your thermal profile so compensate acco
Electronics Forum | Wed May 09 10:40:10 EDT 2001 | davef
First, your primary side component pads should be designed according to SM-782A, "Surface Mount design & Land Pattern Standard". Next if you did that and your secondary side component pads are the same size as your primary side components, your diff
Electronics Forum | Thu Feb 16 14:06:51 EST 2006 | russ
You are pretty much on your own when selecting fluxes. search archives in forums and see what everyone else is using and doing. Whoever you purchased the wave from should be installing this machine, certifying it, and providing training for your
Electronics Forum | Mon Aug 30 16:14:58 EDT 1999 | Dave F
| I am building a board with T1/34 LED's in a 10X10 array there are 12 arrays in a panel. The LED's are body to body in the array, .1 spaced. The LEDS have been autoinserted on a Universal RAD III, so they are cut and clinched. The trouble I am havin
