Electronics Forum | Thu Jun 17 19:52:57 EDT 1999 | Tony
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w
Electronics Forum | Tue May 17 10:11:54 EDT 2005 | russ
I would use a foam fluxer since spraying rosin will make the stickiest nastiest mess you can imagine. 18 layer board huh? You will want convection preheat, both top and bottom preheaters, preheat tunnel of at least 4-5', a chip wave, laminar flow w
Electronics Forum | Tue Jun 13 08:51:37 EDT 2000 | Jason
ok now i have some more answers to questions. the 225F is the temperature as the pcb comes out of the last preheater before crossing the wave. the conveyor speed is anywhere from 3.65-4.00 should it be the same for all boards?? I am using superfl
Electronics Forum | Mon Jun 21 14:55:27 EDT 1999 | JohnW
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w
Electronics Forum | Thu Jun 17 15:18:54 EDT 1999 | Earl Moon
| Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | for example: | | Solder Bridge | 1.verify amount of flux been aplied. | 2.verify turbulance on your solder wave. | 3.etc.
Electronics Forum | Mon Nov 23 19:34:51 EST 1998 | Mike Demos
Charles: Here are a few possibilities you might want to check: 1) Conveyor width -- if the conveyor is too tight this will cause the boards to buckle as they go through the preheat section. We recently had this happen when we changed operators. 2
Electronics Forum | Thu Nov 19 10:12:38 EST 1998 | Brian Conner
| For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave solder a
Electronics Forum | Mon Dec 17 15:11:35 EST 2007 | chef
Blew chunks - thanx for thinking outside the box. Of course there's two sides to every story. Just last week I had a new operator "splash" a couple of boards. Top solder was great, it was all one big solder bridge. Come to find out, the operator forg
Electronics Forum | Tue May 08 09:50:19 EDT 2007 | patrickbruneel
Hi Loco, Good point!! The good old glass plate works just fine as long as the conveyor or carriers have L shaped fingers. A glass plate is usually about a � inch thick (a lot thicker than the actual board). With L shaped fingers the bottom of the gl
Electronics Forum | Wed Aug 23 02:48:11 EDT 2006 | ec
Hi, Appreciate someone could advise or forward a format to me how to work out number of pallet needed for wave-solder if the machine speed is at 1.0m/min, volume per month is 4500 sets, pallet length 0.3 meter, conveyor length 5 meter...... Looking
