Electronics Forum | Thu Apr 01 21:18:31 EST 1999 | Chris Kelly
Glenn, There are both very good VOC-Free fluxes as well as alcohol based fluxes out there. This should be your primary focus if you are so lucky as to have to opportunity to actually select a flux! The use of nitrogen will benefit any no-clean pro
Electronics Forum | Mon Jul 14 16:11:58 EDT 2008 | ck_the_flip
Pat, Try to run a glass plate (yeah I've used these before too), keep your wave pump speed the same, and slow down your conveyor speed. You will find the actual contact between molten solder and the 0.5" grids to be LESS vs. a faster conveyor speed
Electronics Forum | Fri Mar 17 16:39:33 EST 2000 | Larry
We have just installed an omega wave to our W/S machine and are tring to W/S some of our bottom side surface mount components. I am still getting skips on some sot 23's. The component lay out meets all IPC 782 guidelines. I have verified these setti
Electronics Forum | Tue Aug 13 17:34:44 EDT 2002 | pjc
The Electra is Electrovert's top-of-the-line wave solder machine. Just about the best you could get. Conveyor concerns should focus on the condition of the extruded rails. A machine that new should not have a problem, buy worth a look see. Find out i
Electronics Forum | Thu Jul 14 11:52:16 EDT 2005 | davef
Sure you can use SPC charting on the wave setup parameters to warn of impending problems. Examples of useful points of analysis are: * Dwell * Temperature * Pot analysis Certainly there's a range of other process controls that could be monitored.
Electronics Forum | Fri Jun 07 04:57:53 EDT 2019 | gregoryyork
Its more than likely the conveyor is slightly out and needs dropping. You do have a fairly significant contact though so are you sure the Solder pot isnt running too cool for Lead free, needs to be around 275C for good wicking and flow or 250C if lea
Electronics Forum | Sat Sep 11 10:51:59 EDT 1999 | JohnW
Folk's, Been asked / told by my boss to look into our board prepping area for wave soldering and find another way of doing it. Thing's I'm looking at are: PCB Breakout - do you do it before or after wave Connector's that need to be pressed in due to
Electronics Forum | Wed May 26 15:56:08 EDT 1999 | Chrys Shea
| | | we have just started wave soldering passive SMT components and through hole. We are having trouble with voids on the SMT components. It is very random, but effects a lot of TSOT's. We are using an electrovert with a chip wave. Are there any
Electronics Forum | Sun Dec 09 22:54:20 EST 2001 | dburr
It sound you have already discovered to root cause, flux entrapment in the via holes. Short of changing the desing, here are sone suggestions. The main thing is you have to dry out the via holes of the wet flux. Some things to try are: slow down t
Electronics Forum | Mon Mar 20 18:15:05 EST 2000 | Russ
Larry, SOTs are a wonderful thing to try and wave solder! They are about as nice as Tant caps. I have found that shadowing is usually the biggest problem assuming that the other wave parameters are good, in your case it seems that they are. Couple