Electronics Forum | Thu Oct 18 11:59:38 EDT 2012 | jackofallmasterofnone
1) At this time we do not have a design engineer. I have contacted the PCB manufacturer about changing the drill file to close up the diameter on the holes a bit. This should allow the wings on the leads of the component to rest on top of the holes i
Electronics Forum | Thu Mar 08 03:13:20 EST 2018 | rob
Don't go down that route, Juki cut spares support a few years ago on these. Although bits are available from China, you do not want to be swapping used cards. They are both also dog slow in real life whatever you do to them. Especially a 760. We'r
Electronics Forum | Thu Jan 28 15:53:12 EST 1999 | Dave F
| | Hello Netters, | | | | I need some info, Earl or Dave, I have a PCB that exhibits a white layer on solder side. It does not appear to be surface residues (IPA has no effect), but looks like its under solder mask. My first guess is that the LPI
Electronics Forum | Tue Oct 06 17:17:44 EDT 1998 | Chrys
| We are experiencing poor wetting on various components placed on a PCB with En-Tek coating. Is anyone else experiencing simular problems ? We have the following questions: | | 1. How can the thickness of the En-tek coating be measured? | 2. Is En
Electronics Forum | Tue Jun 08 17:52:53 EDT 1999 | Chrys Shea
| | | Hi,my master | | | How to iron out such soldering bridge with below conditions: | | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | | 3.using s
Electronics Forum | Fri Jan 22 15:48:14 EST 1999 | Chrys
| Hello, | | I will be evaluating and qualifying two equipment types. The first is a fountain soldering device. I need practical advice on all the stuff you guys and gals know about as good, bad, ugly, best applications, setup, limitations, and all
Electronics Forum | Thu Jan 28 17:31:20 EST 1999 | Earl Moon
| | | Hello Netters, | | | | | | I need some info, Earl or Dave, I have a PCB that exhibits a white layer on solder side. It does not appear to be surface residues (IPA has no effect), but looks like its under solder mask. My first guess is that t
Electronics Forum | Tue May 23 20:44:13 EDT 2000 | Dave F
Sal: You and Wolfgang are spot on, but let's see if we can blow this out a bit. Before proceding to rattle on ... � PC Card. A credit card-size computer peripheral that add memory, mass storage, and I/O capabilities to computers in a rugged, compa
Electronics Forum | Sun Jan 31 03:28:24 EST 1999 | Jeff Sanchez
| Hello Netters, | | I need some info, Earl or Dave, I have a PCB that exhibits a white layer on solder side. It does not appear to be surface residues (IPA has no effect), but looks like its under solder mask. My first guess is that the LPI solde
Electronics Forum | Thu Jan 28 16:29:03 EST 1999 | Tom B
Okay, Another question, if the soldermask in not cured, then it is washed will water ingress (from wash or ambient ) play havoc with capacitance or dielectric of PCB. I mean will my crystal and clock circuits start "Y2K'n" on me. OR will my PCB go