Electronics Forum | Sat Apr 10 08:17:21 EDT 2010 | nagesh
Dear All, I have a problem with the BTU-paragon -150 reflow oven,with the heaters getting off with Overtemperature Alaram. But the actual temperature on board not exceeding the 255 peak temp. Pls. advice & thx in advance for your sincere postings. R
Electronics Forum | Mon Apr 12 12:01:27 EDT 2010 | tommyttr
One of the air temp sensors by the blower is bad. Unplug them and check each to find the defective one.
Electronics Forum | Thu Nov 12 06:38:00 EST 2009 | nagesh
Dear All, I have a problem with the BTU-Paragon 150 10 Zone Reflow Oven. Am not able to lift the HOOD using the buttons on the Main control panel. I have checked the Lift hood switch & Ok. Pls. advice / Suggest. Thx in advance for all your sincere
Electronics Forum | Wed Nov 18 13:00:16 EST 2009 | evertonsanches
Dear All, > > I have a problem with the > BTU-Paragon 150 10 Zone Reflow Oven. Am not able > to lift the HOOD using the buttons on the Main > control panel. I have checked the Lift hood > switch & Ok. Pls. advice / Suggest. > > Thx in > advanc
Electronics Forum | Thu May 30 09:41:30 EDT 2013 | giangi
Hello, I have 4 BTU Paragon 150s in the factory where I work for. One of them has a weird behaviour: in order to get the same thermal profile as for the other ovens, I have to increase a lot all the temperatures. I think there is something wrong with
Electronics Forum | Wed Nov 18 12:56:06 EST 2009 | evertonsanches
Hello I had similar problem on VIP 70A. Try to check auxiliar contact from located into front panel. Everton - BRAZIL
Electronics Forum | Mon Apr 12 09:13:45 EDT 2010 | toddl
Check your "over temperature module" for both top and bottom zones when the alarm is active, there is a bank of LED's on the bottom of this module. Monitor it to find out if the same zone keeps activating the alarm, if so check your TC for that zone.
Electronics Forum | Mon Jun 03 16:52:22 EDT 2013 | smellew
Hi Yes, there is an FCU calibration procedure which may help you, for this information please contact us direct. Email llew@SurfaceMountEngineering.com Web: http://www.SurfaceMountEngineering.com Fuji, DEK, BTU, Ersa & Vi Technical support & service
Electronics Forum | Mon Sep 19 13:24:05 EDT 2005 | cyber_wolf
OK guys here is the skinny..... We need an oven that can handle lead free temps without slowing the belt speed under 28 or so in. per min. BTU tells me that they don't recommend an oven that maxes any less than 350 C. Is anyone using a paragon 150
Electronics Forum | Tue Sep 20 04:28:31 EDT 2005 | Rob
Pyramax 150 is a low cost newer version of the Paragon 150, the Paragon is a newer version of the VIP. The VIP is great for lead free (as confirmed to us by BTU, who told us it was pointless upgrading that particular oven to a Pyramax). You may nee
