Electronics Forum | Sat Apr 10 08:17:21 EDT 2010 | nagesh
Dear All, I have a problem with the BTU-paragon -150 reflow oven,with the heaters getting off with Overtemperature Alaram. But the actual temperature on board not exceeding the 255 peak temp. Pls. advice & thx in advance for your sincere postings. R
Electronics Forum | Thu Nov 30 16:36:04 EST 2006 | techgonecrazy
I think we can control temp... but I will have to look into it further and see. I know the ovens have flow control... but as I mentioned on the last message, our BTUs are operating off of a huge chillers on the roof of the plant.(once again, not sure
Electronics Forum | Mon Apr 12 12:01:27 EDT 2010 | tommyttr
One of the air temp sensors by the blower is bad. Unplug them and check each to find the defective one.
Electronics Forum | Thu Nov 12 06:38:00 EST 2009 | nagesh
Dear All, I have a problem with the BTU-Paragon 150 10 Zone Reflow Oven. Am not able to lift the HOOD using the buttons on the Main control panel. I have checked the Lift hood switch & Ok. Pls. advice / Suggest. Thx in advance for all your sincere
Electronics Forum | Wed Nov 18 13:00:16 EST 2009 | evertonsanches
Dear All, > > I have a problem with the > BTU-Paragon 150 10 Zone Reflow Oven. Am not able > to lift the HOOD using the buttons on the Main > control panel. I have checked the Lift hood > switch & Ok. Pls. advice / Suggest. > > Thx in > advanc
Electronics Forum | Thu May 30 09:41:30 EDT 2013 | giangi
Hello, I have 4 BTU Paragon 150s in the factory where I work for. One of them has a weird behaviour: in order to get the same thermal profile as for the other ovens, I have to increase a lot all the temperatures. I think there is something wrong with
Electronics Forum | Thu Nov 30 16:31:40 EST 2006 | techgonecrazy
This has been a problem from the start. I used a digital flowmeter to check exhaust and both sides are pretty even, however, I do not know if its exhausting too much or not enough, just going on the PE specs...but then again...do they really know. I
Electronics Forum | Wed Nov 18 12:56:06 EST 2009 | evertonsanches
Hello I had similar problem on VIP 70A. Try to check auxiliar contact from located into front panel. Everton - BRAZIL
Electronics Forum | Mon Apr 12 09:13:45 EDT 2010 | toddl
Check your "over temperature module" for both top and bottom zones when the alarm is active, there is a bank of LED's on the bottom of this module. Monitor it to find out if the same zone keeps activating the alarm, if so check your TC for that zone.
Electronics Forum | Wed Nov 29 16:52:35 EST 2006 | techgonecrazy
OK... My problem with BTUs is that they are getting stopped up because the flux is not going from vapor form to liquid form; instead it is crystalizing (looks like a blizzard took place in the flux box and chiller boxes) and clogging up the flux box,
.gif)
