Electronics Forum | Wed Jul 08 10:29:14 EDT 2015 | goodting
Dear SMT Specialists Had anyone encountered GSM ADvantis zeroing failure problem? The x-axis is idle while the y-axis is waiting to be activated. My initial guess is either Axis control board or machine configuration conflicts. How to fix it? any le
Electronics Forum | Mon Feb 02 11:51:54 EST 2004 | jsk
error code: motor comms failure.card3, Axis123 fatal error-reinitialize machine I swapped x3 and x4, and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, jsk
Electronics Forum | Thu Jul 20 10:48:43 EDT 2006 | pms
Ev, This error could be caused by any number of problems. Is there an error message in the message window before hardware initiation error? If so, what is it? A failure in any axis (x,y,z,c,theta,y-wagon,tray-wagon) could cause your symptom. Paul
Electronics Forum | Wed Jan 27 17:32:51 EST 2016 | billthebuilder
We do High Mix, Low Volume and are looking for the best inline AXI with the criteria of industry-leading automation capabilities. The abilities to program offline, automatic conveyor width adjustment and board alignment are important to us. We want t
Electronics Forum | Thu Sep 04 09:40:14 EDT 2014 | rgduval
I'm surprised MyData is pushing the service call. They're usually pretty good at walking you through some troubleshooting steps before going straight to the service call. So, the failure sounds like an encoder failure; the encoders are attached to
Electronics Forum | Mon Sep 25 12:50:42 EDT 2006 | chris g
Daxman, The diagnostic results didn't look very pretty. Especially on the vision x standard deviation. Any time there is an asterisk, that is a bad thing. The failure number for all axis, excetp theta, is .0002. Could need more air flow to the x
Electronics Forum | Thu Mar 24 23:34:55 EDT 2022 | glasscake
My Koh Young 3030VAL errors on the homing routine. The "DTool" "MCS" gives me an error "Before homing, X-AAxis already checked negative limit..." "Before Hoking, Y Axis already checked negative limit..." "Please turn off the control-power-switch, an
Electronics Forum | Mon Feb 10 09:49:32 EST 2003 | pjc
For manual X-ray systems: Kv power to start off with. Depending on what type of components you have to X-ray, you may be ok w/ just a 90Kv system, for example. Its not all about Kv though. With most systems you can adjust to quantity of X-rays you ar
Electronics Forum | Fri Jul 20 07:09:29 EDT 2007 | chrispy1963
Sr. Tech, youre absolutely correct that the X-Wagon (pancake) motor is the one which will do final positioning when moving to a programmed position. The X Axis motor in back of the machine is used for rapid traverse of the axis. I was thinking more
Electronics Forum | Mon Jun 26 20:34:14 EDT 2000 | Dave F
Gary: Allow expand on this topic a bit. Back in the gray skied past when people wore calculators on their belts, rather than pagers n Palms, and didn�t drink California spill, they used HASS that you mentioned and HALT (Highly Accelerated Life Test
