Electronics Forum | Fri Sep 26 16:45:30 EDT 2003 | kenBliss
adlsmt You have stated that an OEM will not sell you a part for a used machine that was built by the OEM and is still supported per the OEM�s standard part policy unless you buy a contract. I will admit I find that hard to believe. Unless you are
Electronics Forum | Fri Oct 03 01:03:15 EDT 2003 | Truett H.
I would discourage the use of city water at all - where rinsing electronic parts is concerned, it contains too much contamination. If practical, route DI water to your first tank and implement some aggitation (either nitrogen bubbles from the bottom
Electronics Forum | Mon Oct 13 14:30:56 EDT 2003 | jsherrow
Our customer is starting to see some solder joint > failures during their extensive testing > proceedures. Specifically with an SMD/DIP device > that has a very small foot in relationship with > the pad on the PCB. (By SMD/DIP device I mean a >
Electronics Forum | Tue Nov 11 16:01:09 EST 2003 | KSimpson
Adam, As for stripping the boards.. get them right to start with. Believe me you don't want to clean them. If you have to remove the coating most conformal coating brands offer a removal agent that has been tested on most all component ranges. IF yo
Electronics Forum | Tue Nov 18 15:03:39 EST 2003 | Mark
Yup. I'm attempting a small, but very important experiment. I need to solder several Lead-Free Globtop BGA parts to a Pin-Socket interposer assembly. I'm trying to come up with the best way to do this. I'm thinking of using lead-free solder paste, (b
Electronics Forum | Fri Jan 30 16:49:21 EST 2004 | Mike Zadrejko, Videotek, Inc.
Barney, We currently have 3 Contact Systems machines, (1) C3AV and (2) C3AVXs and I can't say enough good things about the machines or the support. It has always, always been there since we started dealing with them in 1991. The Service Dept personn
Electronics Forum | Tue Feb 17 10:55:49 EST 2004 | bobbyv40
Hi Dave, 1. As far as speed of removing componants, we use a board preheater to bring board temp to about 150 C. Then add a flux and then flood all 4 sides of the componant with the low temp solder. Using a suction tool the part comes right off. The
Electronics Forum | Sat Mar 27 12:32:34 EST 2004 | Bill
I am looking for technical support for our two RTI 6500 AOI equipment. We had worked with CR-Technologies in the past --but from what I understand, they had been absorbed by PhotoDynamics. Which is where you end up if you try to go to the old CRTe
Electronics Forum | Mon Apr 12 10:59:49 EDT 2004 | Takfire
Hello. I have a customer that continues to have problems with their bulk cassette feeder. The customer is complaining about shorted parts that result from bulk cassette feeding operations. They are quick to claim that the failure is related to the
Electronics Forum | Tue Jun 01 16:12:49 EDT 2004 | gregf912
The 10k rebuild does not need to be applied every 3-4 months as previosly stated. A cp machine that is running 100% of the time on a 24/7 basis will tack up 10k hours in 12.4 months. Now we all know that this is impossible due to parts shortages, pro
