Electronics Forum | Wed Jun 11 16:41:57 EDT 2014 | isd_jwendell
With Essemtec software you can specify to turn on vacuum once the nozzle is down at the part. The default method is to turn on the vacuum while the nozzle is up, but starting to move down. For light/tiny parts this can have the effect of making them
Electronics Forum | Wed Nov 24 07:02:15 EST 1999 | JAX
Larry, Carl's right about vision 254 and 255 but I believe CP4's can be set up to check for a part on the nozzle,(parts check sensor)like any other CP. This could be activated to make sure parts are being placed. Then again CP4's might not ha
Electronics Forum | Wed May 05 01:42:06 EDT 2004 | fastek
Kuru- If you have a bad tactile sensor....find out what the part number is and you can order it from MPM. If you don't have the part number, MPM won't help you unless you pay a price to register the machine. You're other solution is to post an ad on
Electronics Forum | Thu Mar 07 09:03:03 EST 2002 | cabjerk
After the IP3 is stopped by any means ie. Estop, cycle stop, or machine runs out of parts, upon restart the table will go to load position, unclamp, reclamp, read the fids and then proceed as normal. The problem is that if we already have fine pitch
Electronics Forum | Tue Nov 01 20:40:03 EDT 2011 | mikeincal
What may be happening is an early trigger of your vacuum sensors during production due to a clogged tip or vacuum line in the head. What happens during production is that the Y axis gets into position, and then the vacuum sensor input is monitored on
Electronics Forum | Fri Apr 06 07:32:33 EDT 2001 | Claude_Couture
Thanks for the tips. I'll have to check with the designers if they can accomodate the height if I was to use parts with stand-off. The bigger holes was already suggested, but they don't want to change them until a new revision on the product comes o
Electronics Forum | Fri Apr 06 07:32:54 EDT 2001 | Claude_Couture
Thanks for the tips. I'll have to check with the designers if they can accomodate the height if I was to use parts with stand-off. The bigger holes was already suggested, but they don't want to change them until a new revision on the product comes o
Electronics Forum | Fri Apr 10 04:09:24 EDT 1998 | Ben Salisbury
Has anyone Ran parts on the CPII taller than 4mm? If so, what adjustments were made to the machines to accomodate such a part?
Electronics Forum | Thu Apr 16 14:44:31 EDT 1998 | Doug Carter
| Has anyone Ran parts on the CPII taller than 4mm? | If so, what adjustments were made to the machines to accomodate such a part?
Electronics Forum | Tue Oct 02 10:51:31 EDT 2012 | jimmyboz
What machine? Normally part height in the parts description would dictate placement pressure. In general, paper provides a better centered pick-up but may interfere with the pick-up(paper fibers)
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723