Electronics Forum | Fri Jan 13 12:36:48 EST 2023 | servin6154
There are a couple of things you can try that seemed to help me with this problem. 1.Get your HMS height off of the paper tape halfway between the pocket and the edge of the tape. 2. Change your "pick stroke" for that part to "0" 3. Check you compon
Electronics Forum | Fri Apr 24 07:27:28 EDT 2009 | jdengler
Hi Nick, I took a feeder that was broken and modified it. I glued shims in place to set the sensor height with. I glued a block of metal to work as a stop for the Y axis. Then for the rotation I use a piece of paper to see were the emitter is poi
Electronics Forum | Tue Aug 04 09:02:34 EDT 2009 | kpm135
We replaced the tactile sensor's linear actuator on a MPM Ultraprint 2000 HiE. Now we are getting a Tactile Hardware limit error every time we try to find the stencil height. I was hoping some one could explain why we're getting this error and any i
Electronics Forum | Tue Nov 15 12:24:12 EST 2011 | nevercry14
Well try to run in idle n as soon as the mtu. Goes to pick up part on tray it goes down but when homing back in position doesnt flag sensor because position is off.so the sz sensor not bieng flaged. Any ideas
Electronics Forum | Tue Nov 15 22:08:58 EST 2011 | nevercry14
Thats the odd part that i can zero set no problem just when i try to run idle the sz sensor ok when goes down but when it goes back up its not bieng retracted up so sensor stays off n eror acurs again any ideas.
Electronics Forum | Mon Mar 25 20:25:19 EDT 2013 | vikkaraja
Jimmy, thats the hard part. I wish I knew which sensor is causing it. There are so many sensors it's very hard to narrow it down to a specific one. I have not given up yet. Thanks,
Electronics Forum | Fri Jan 07 16:30:53 EST 2022 | tey422
I have a quick question, what's the tallest (highest) SMT part you ever encounter? 1.5 inch or more? I have to set a depanel router's clearance height. It would need to recalibrate again every time if the spindle or camera's height is adjusted. There
Electronics Forum | Tue Dec 06 18:29:45 EST 2005 | darby
You may also wish to check the speed controllers for both descent and ascent. The higher the ascent speed the more force the jaws close with. It can be difficult to achieve a "good" nozzle placement height as this is mechanically set and your lowest
Electronics Forum | Thu Mar 02 04:50:25 EST 2006 | bobpan
oh....for the feeders moving 2 parts....you must teach a pickup repeat. Make an extent in the pickup editor and attach it to repeat with pick and make it a 2x1 with an 80 mil offset. The machine will then pick the part that is out of the sensor first
Electronics Forum | Fri Mar 02 15:03:39 EST 2012 | davef
21. What is the recommended way to connect the sensor? Answer (Pellistors) For VQ500 series sensors please use sockets http://www.cambion.co.uk/Catalogue/Parts/1813.htm. For other pellistors connect to header legs by soldering or mechanical methods
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
