Electronics Forum | Wed Jun 08 05:40:54 EDT 2022 | leeg1
Its quite easy to do a simple excel compare logic if using manufacturers part numbers in your program and comparing against a customer BOM.
Electronics Forum | Wed Jun 01 12:06:49 EDT 2022 | proceng1
I am not quite clear what you are asking, but I'll give it a shot. Once the P&P program is put into the machine, the operator will load a bare board and step through the program using the machine camera to verify that part outlines match up to the bo
Electronics Forum | Sat Jul 27 17:21:19 EDT 2013 | ericrr
A mistake happened at our company before I got there where a wrong value was used, so now we have to check it with someone else to make sure the old empty reel is the same value as the new full reel. Some months after I started, I decided to check t
Electronics Forum | Tue Apr 06 13:24:19 EDT 2004 | smtpro
Is any one using either of these part verification systems? If so how well do they work and what was the general cost? Thanks for any info.
Electronics Forum | Wed Apr 07 09:43:55 EDT 2004 | Alan
We currently use the bartector system on our CP6. It has saved us quite a few times with wrong part numbers being loaded on the wrong location. (rework for certain parts would have been a nightmare) It is extremely easy to use. I was not involved
Electronics Forum | Thu Oct 29 09:34:14 EST 1998 | R Hamilton
Does anyone know of any software programs that will verify a Pick & Place program to the Bill of Materials (BOM)? Verify meaning the Part # and Ref. Des. matching of the two files. We use GCPlace to merge our BOM with X/Y file but ocasionally Ref
Electronics Forum | Wed Apr 21 07:32:04 EDT 2004 | podge
Hi, We have been using the Crest Solutions Reelscan system here for about 3 years on 8 lines and it has pretty much eliminated wrong part placement. We use it on a variety of SMT placement machines and i believe it can be adapted to any type of place
Electronics Forum | Thu Jul 12 08:49:14 EDT 2018 | robl
Started with a 1 part shield and we had an 0201 tombstone due to the pad design. We changed the pad design but the customer wanted to be 100% sure, so we moved to a 2 part, adding the lid after verification. We also trialled the original 1 part c
Electronics Forum | Thu Oct 29 11:15:58 EST 1998 | Scott B
| | Does anyone know of any software programs that will verify a Pick & Place program to the Bill of Materials (BOM)? Verify meaning the Part # and Ref. Des. matching of the two files. | | We use GCPlace to merge our BOM with X/Y file | but ocas
Electronics Forum | Thu Oct 29 10:11:09 EST 1998 | Scott Cook
| | Does anyone know of any software programs that will verify a Pick & Place program to the Bill of Materials (BOM)? Verify meaning the Part # and Ref. Des. matching of the two files. | | We use GCPlace to merge our BOM with X/Y file | but ocas
