Electronics Forum | Mon Jul 22 09:51:06 EDT 2002 | pjc
They have the part because they're selling the part. UIC's Replacement Parts Division doesn't care about when a machine was built. All they're concerned about is what parts are selling. That old part I'll bet was for an axial VCD inserter or sequence
Electronics Forum | Tue Aug 24 09:04:59 EDT 2004 | Dreamsniper
I agree with Rob's Common Parts Report and purchasing should be aware that with common parts a single reel parts will not work. They need to stock more supply or if this part is a common part and of low quantity (say 2 per PCB for 6 different product
Electronics Forum | Mon Mar 31 09:16:41 EDT 2008 | davef
What is changing the marking on the part? * Is flux residue coating the part to change the the way light reflects from the part surface? [Run a board with tape on the part, then remove the tape prior to AOI] * Is the heat of the oven changing the mar
Electronics Forum | Mon Jan 26 13:30:36 EST 2009 | evtimov
Hello, usually you will place your themocouples on the most critical parts on your board. I would say, very big parts, very sensetive to the temperature parts, heavy parts, parts with big heat-sink.... The easiest way is to solder your thermocouple
Electronics Forum | Tue May 07 13:42:45 EDT 2013 | tanderson
These are dropped/mis-placed by the machines. We have older Quad QSP-2's. My concern is it's easy for the operators to overlook the dropped parts, keep running the job and when they're done, throw away parts (inexpensive resistors aren't such an issu
Electronics Forum | Thu Oct 21 13:31:41 EDT 2004 | LarryL
With the current failures of the Medium Power Linear Amplifier manufactured by RFMD (PN: RF2114), can anyone recommend a replacement part. The above part is used in a GPS transmitter, where I only have one recommended part on the part list. The manu
Electronics Forum | Thu Mar 30 13:09:08 EST 2006 | bvdb
The cover tape that seals the parts into the reels on our feeders always uncovers a few parts (up to ten 0805 parts) before the part can be picked. So removing a partial reel always results in the loss of a few parts. Putting a partial reel back on
Electronics Forum | Wed Oct 25 19:50:04 EDT 2023 | wijim
Maintain a comprehensive component library or database that includes information on all the parts used in your assemblies. This should include not only the manufacturer part number but also other attributes like footprints, values, and descriptions.
Electronics Forum | Sat Oct 18 09:30:43 EDT 2008 | hussman
Sounds like a part problem. You can SOMETIMES over come this with a hotter profile. We see this a lot with brokered parts. Seems like a lot of people are rejecting parts because a lot of companies haven't perfected their RoHS process, yet produce
Electronics Forum | Fri Oct 01 00:44:41 EDT 1999 | Hon Choi
If permanent set processing is used, designate the permanent set table name (PST). The Separator uses the PST to restrict the allocation of specified parts to certain feeder positions on the unit (device) table. The PST is mainly used for efficiency