Electronics Forum | Wed Jun 25 10:29:32 EDT 2003 | caldon
Hey Mike- We ran into the same thing when we purchased a Large CanadianManufacturers repair business. We were creative and first used an ESD bag cut open (Simulate the paper idea) then we used a 3M parts bin and would tip it on its corner to funnel t
Electronics Forum | Tue Jan 31 02:59:18 EST 2006 | jgarver1
You also should check to make sure you have blow off at the placing station set properly. I have seen machines with the flow control valve shut completely off not release parts properly. The parts end up in the scrap bin and the machine thinks they
Electronics Forum | Wed Jun 16 15:07:00 EDT 2004 | jsmith01
I ran some test samples with a water soluble past (Amatech ws488). I also tried hand soldering using an Alpha ws375 wave soldering flux and some old fashioned RMA. The results are pretty much the same. Some of the joints look a better that others b
Electronics Forum | Mon Dec 11 14:26:11 EST 2023 | proy
Looking for ideas/conversation on how people handle short strips or leftover SMT parts in inventory We do a lot of high mix low volume jobs we often have strips or even parts in bags which we need to keep and inventory. Presently the non reels are
Electronics Forum | Mon Feb 25 17:01:38 EST 2008 | slthomas
In that case the same tools can apply, just different implementation. We might use any a number of visual aids for an assembly, one for each component type (resisors, capacitors, ICs, etc.). In the case you're describing we might color code the lo
Electronics Forum | Tue Jun 20 16:09:29 EDT 2023 | nickadams
We have a Contact System CS400E with a Rotary Bin model CS201 with 90 bins and we're sort of new to programming it and are wondering how we can program the bins so that we can assign a part number to a bin. What happens now is it always goes to the f
Electronics Forum | Sat Mar 06 08:35:21 EST 1999 | Dave F
| Clarissa, | | Dave had good suggestions. We load several boards manual at this time. We set our components up in clearly marked bins. The documentation includes a chart with the part number, bin number, reference designator and color code for t
Electronics Forum | Wed May 16 12:53:26 EDT 2012 | deanm
CS-400C: As with anything, once you are up on the learning curve its really not that bad. The "E" machines should be easier due to the touchscreen and the floppies are PC compatible unlike the "C" and "D". There are third party software providers tha
Electronics Forum | Thu Oct 31 08:58:56 EDT 2013 | jchosler
We have the E's with a dual picker. The warehouse is currently split into 1114 different part numbers by splitting some bins between 2 different part numbers. We also do share common part numbers on the outside bins of the warehouse. We have a total
Electronics Forum | Mon Apr 28 09:33:34 EDT 2003 | chrissieneale
This may be a really silly question but does anyone pick up and hand place the reject parts from the scrap bins of the machine? My attrition rates are out of control and i think this would not only highlight the problem but also save oodles of money
.gif)
