Electronics Forum | Wed Aug 07 11:07:14 EDT 2013 | garyck
On last question. Is it possible to feed loose resistors into the machine one at a time?. We use a lot of parts where yearly usage is less than 1000 per year. Gary.
Electronics Forum | Mon Aug 05 22:10:38 EDT 2013 | jaimebc
We have HRFT-301U ( staple bend) is fairly easy to set up. All you need is t-handle Allen that I believe is provided with the machine. All adjustments to form a part, both pitch and lead length are mechanically adjusted by sliding the forming and c
Electronics Forum | Thu Sep 19 15:39:16 EDT 2019 | qanalyst1
When baking parts at 90C that require 15 hours bake time with parts that require 25 hours bake time, is it acceptable to open the oven and remove the former (15 hours) parts and then continue the 25 hours cycle for the remainder of the parts in the o
Electronics Forum | Wed Mar 03 11:18:59 EST 2021 | guitarguy68
We've got a couple of old jumper wire formers here at our workplace that I'm looking for a part for. They're originally from the Eraser Co. They no longer have any parts for this. I'm going to attach 2 photos that show the former and the part we n
Electronics Forum | Tue Dec 16 16:14:20 EST 2003 | Bill
We are in need of a replacement conveyor belt for an unload-end conveyor(post wave solder). The part number we had at one point (formerly PCT automation) was 65-4008-4 (Belt, Flat-W=23.75 L=171.70) green high temp conveyor belt. Any help would be g
Electronics Forum | Tue Jul 02 14:35:50 EDT 2024 | proceng1
Nordson bought ACE, and then NORDSON dropped support. TMSSOLUTIONS .US is supporting them now. Some of the former ACE employees started a company and acquired the spare parts and documentation from ACE. Ryan is the guy to talk to. Have your machin
Electronics Forum | Fri May 22 17:48:48 EDT 2015 | aemery
It's your first line, go with established manufacturers. Whether new or used it ultimately comes down to does the tool do the job and how well is it supported (labor/parts) if it does break down. I am a former field eng. with Speedline and now run
Electronics Forum | Fri Nov 30 05:43:27 EST 2018 | alpha1
If the part is kicking up on one side or the other make sure you've done the following: Replaced the inside formers, shoulder screws, shear block and o rings. It sounds like you have the clinch covered. Also check the driver tips. If they are smooth
Electronics Forum | Wed May 02 22:33:44 EDT 2001 | davef
Silvio Dante (played by former E Street Band Guitarist Steve Van Zandt, in his acting debut) has even turned an extremely passing resemblance to Al Pacino [Godfather, Part III] into a personality; he�s forever curling down the corners of his mouth an
Electronics Forum | Fri Nov 30 14:38:42 EST 2007 | ratsalad
One of our former SMT Technicians used a component we pick and place for this purpose. The component is a bond pad that is soldered to a ceramic PCB during SMT assembly. The assembly is now obsolete. I tried looking up the manufacturer's part nu
