Electronics Forum | Tue Dec 06 18:29:45 EST 2005 | darby
You may also wish to check the speed controllers for both descent and ascent. The higher the ascent speed the more force the jaws close with. It can be difficult to achieve a "good" nozzle placement height as this is mechanically set and your lowest
Electronics Forum | Tue Sep 12 11:50:12 EDT 2023 | ttheis
I heard a similar story from a colleague on these machines. Same thing- head and beam not secured for transit and banged around whole trip. I think the beam ended up bent in that case and the machine could never be calibrated or repaired. Don't know
Electronics Forum | Tue Dec 06 02:59:09 EST 2005 | darek
Lately we purchease second hand CSM 84V. During placing parts, we notices that few components are damaged (mmelf, 0805). What we done: - the position of pcb was decreased - the jaws moved little bit outside. Components after that are still damaged. H
Electronics Forum | Tue Dec 06 04:38:43 EST 2005 | mskler
check the placement height of the head, That can be checked by manual up & down of head on conveyor the nozzle should just soft touch the conveyor. Also check the down speed of head.
Electronics Forum | Tue Dec 06 05:40:12 EST 2005 | ajay
we also faced similar problem in fuji cp643. addition to your suggestion - mainly in program PCB thickness, component height checked & set correctly , then problem solved.
Electronics Forum | Tue Dec 06 08:11:41 EST 2005 | lwright10
is the Chuck set correctly on the collers, Wide jaw Soft spring & Narrow jaw hard spring. Also check the pick up angle in the feeder file.
Electronics Forum | Wed Dec 07 06:27:12 EST 2005 | sayyarif@aecl.com
Dear, i faced the same problem. slow down the transport speed, increase the component hight & make the pick-place soft. Best regards.
Electronics Forum | Tue Dec 20 07:58:32 EST 2005 | dwensker
Thank you all for your info. Our problem is fixed. We did as you mention: - chuck set correctly on the collers, Wide jaw Soft spring & Narrow jaw hard spring - make the pick-place soft - slow down the speed controllers for both descent and ascent r
Electronics Forum | Tue Dec 20 12:09:33 EST 2005 | randygray
Hello, I have a CSM 84VZ for sale. This machine runs except for a sensor problem in the Z upward motion when you attempt to zero the machine. Please let me know if you are interested and I will send you complete details. Best Regards, Randy Gray
Electronics Forum | Wed Jun 06 12:56:04 EDT 2007 | appliedi
Good Morning: We are looking at trying to find someone to service our CSM-84VZ and were wondering if you knew of any techs we could call who would walk us through the service process over the phone? Thank YOU Mark Chisholm mark@appliedi.com
.png)
