Electronics Forum | Mon Aug 20 14:39:42 EDT 2012 | davef
Investigate these links * http://www.ehow.com/how_12128475_determine-number-parts-partial-reel.html * http://ox3.com/pprX.php
Electronics Forum | Mon Aug 20 07:17:36 EDT 2012 | ericrr
Hi we have Juki KE-750L's is there any program to work out how many parts left on the reel, on the machine, the placement program does have a option to keep this number, but once you finish the run and start a new run the figure is lost. Unless I mis
Electronics Forum | Wed Aug 22 07:24:34 EDT 2012 | ericrr
how about this for resistor & capactors with 4mm pitch, all measurements in millimeters. cell A1 "Input inside diameter" answer in cell B1 cell A2 "Input outside diameter"answer in cell B2 cell A3 "Input layer width,(from inner to outside layer) (no
Electronics Forum | Tue Sep 18 10:52:14 EDT 2012 | sarason
Sounds like a plan. The usual way is to count how many you use on the job either by pre-calculation. Or how many clicks the machine counts and save the data before switch off, then drop it back into a spread sheet. This depends very much on the mach
Electronics Forum | Wed Dec 02 13:03:50 EST 2009 | jesalinas47
Hi , I provide machines to count SMT parts that come on reel , my customer wants to improve his counting method , he is having problems when delivering material to prodution floor , because the number on the reel (physical) is not the same as it is w
Electronics Forum | Wed Dec 02 22:29:30 EST 2009 | davef
Give him the whole reel and have him build until he runs out of parts and asks for more. Make him keep track of inventory. Your job is to give him a bad time about too much shrinkage.
Electronics Forum | Mon Dec 07 17:11:41 EST 2009 | stepheniii
This happens on the counting area which it is > into warehouse , Have you confirmed that? Have you seen empty pockets? Or are you taking someone's word for that? How many extra parts does the stockroom give to SMT to cover droppage?
Electronics Forum | Fri Dec 04 15:36:24 EST 2009 | toddl
We have purchased a similar machine from Manncorp and have had good success. It does check for empty pockets.
Electronics Forum | Thu Dec 03 17:50:29 EST 2009 | jesalinas47
This happens on the counting area which it is into warehouse , we are looking for a poka yoke to avoid delivering reels with a wrong quantities , the question is : have you implemented any poka yoke in your warehouse ? how it works ? I could suggest
Electronics Forum | Thu Dec 10 11:07:48 EST 2009 | Lorena Flores
Hello! I think the point here to have a reliable counting system. No matter if it is given 5000 out of 5000 or 6000 out of 5000. What Jesus means is that there is a problem because the qty that the label says after the reel is counted doesn't match
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
