Electronics Forum | Wed May 13 15:57:43 EDT 2020 | azdback
We have been working on an intermittent error on our hydra. And it seems to happen only after several hours of production have passed, it doesn't happen during the first part of the shift. Our hydra goes from working fine for several hrs to making
Electronics Forum | Thu Nov 24 16:53:03 EST 2011 | dontfeedphils
Oh wow, I suppose that would fix it huh? That's too bad that the whole unit had to be replaced, but look on the bright side, you should have a decent amount of spare hydra parts now right? haha
Electronics Forum | Mon Oct 12 01:20:42 EDT 2020 | azdback
LandrySMT, after monitoring the errors and considering what we replaced, I also decided to replace the Z hydra motor and encoder. That fixed our problem. I looked at your message and I agreed that the next step was to replace this part. We ran hi
Electronics Forum | Wed Dec 07 15:54:28 EST 2011 | comando
this bulbs never have been replaced but the image look ok I would like send you a part placement image and i don't know how , if you want send me you e-mail to send the image
Electronics Forum | Wed Sep 11 18:01:27 EDT 2013 | huske
I've had that issue before, here's how you fix it, or at least it worked for me. Also assuming you didn't destroy a shaft, which should be obvious. Follow the flexible vacuum tubes to the top of the hydra shafts, you should see a red light below the
Electronics Forum | Mon Dec 18 21:23:13 EST 2006 | jgarver1
The spline shaft is bent. I have replaced a number of these over the years with the exact same symptoms. How is your placement? Your 180 degree placements should be skewed if the shaft is bent. 0 Degree placements are typically acceptable due to
Electronics Forum | Fri Jun 02 17:19:56 EDT 2000 | Big K
I am currently experiencing several problems with QFP's on one of our IP3's. The first problem is with QFP240 devices. We are experiencing a high reject rate with these parts when using vision type 100. What appears to happen is that the vision syste
| 1 |
winsouce.jpg)
