Electronics Forum | Wed Aug 18 08:38:46 EDT 1999 | Jason Gregory
| Is there process by which one can do a double sided reflow (SMT on both sides) in one pass through the oven? | Paul, Here's a way it might be done. Screen your bottom side with paste (if only passives, 0603-1206 & sot 23's), dispense glue for sam
Electronics Forum | Sat Dec 11 12:15:21 EST 1999 | Steve Thomas
We have a pretty challenging board (2-up panel, 15"x20", 48 20mil pitch QFP 100's and 2 25mil QFP128) that gives us LOTS of lead bridging on the 20 mil parts. There is typically very poor wetting on these parts also, and some joints just flat aren't
Electronics Forum | Wed May 26 13:30:58 EDT 1999 | JohnW
| we have just started wave soldering passive SMT components and through hole. We are having trouble with voids on the SMT components. It is very random, but effects a lot of TSOT's. We are using an electrovert with a chip wave. Are there any obv
Electronics Forum | Wed May 26 14:24:13 EDT 1999 | Boca
| | we have just started wave soldering passive SMT components and through hole. We are having trouble with voids on the SMT components. It is very random, but effects a lot of TSOT's. We are using an electrovert with a chip wave. Are there any o
Electronics Forum | Wed Aug 11 13:44:40 EDT 1999 | Paul Wareham
We are using a mixed technology process with mostly through-hole parts plus some SMT IC's on the component side and some passive SMT parts on the solder side. We do not have a proper wave soldering machine for doing solder side SMT (double wave or o
Electronics Forum | Fri Aug 13 07:18:19 EDT 1999 | Brian Conner
| We are using a mixed technology process with mostly through-hole parts plus some SMT IC's on the component side and some passive SMT parts on the solder side. We do not have a proper wave soldering machine for doing solder side SMT (double wave or
Electronics Forum | Tue Apr 25 10:42:38 EDT 2006 | TMC
Almost all of the components on the bottom side are passives however, there are a couple of mBGA's and qfp's. I am aware that even if the components on the bottom do get reflowed, surface tension of solder will hold them in place. As far as IC's, w
Electronics Forum | Thu Feb 17 22:30:09 EST 2000 | Dave F
Alberto: There's no rules, but it works sorta like this: RESISTORS Usually marked in ohms using a standard code: First two numbers is the value Third number is the multiplier 102 = 1.0 x 10� ohm = 1000 ohm = 1 kW CAPACITOR Usually not marked. When
Electronics Forum | Thu Feb 17 22:30:09 EST 2000 | Dave F
Alberto: There's no rules, but it works sorta like this: RESISTORS Usually marked in ohms using a standard code: First two numbers is the value Third number is the multiplier 102 = 1.0 x 10� ohm = 1000 ohm = 1 kW CAPACITOR Usually not marked. When
Electronics Forum | Wed Apr 21 18:24:13 EDT 2004 | pjohnson@volterra.com
Simple process - we use similar Kester solder brands of "no clean" low residue solder wick to clean our pads, then brush with isopropyl, and apply Kesters brand of tacky flux under a Leica 6x microscope. We do this on 7x7mm and 9x9mm packages. This w
