Electronics Forum | Tue Jan 17 17:28:47 EST 2006 | mrduckmann2000
Adlsmt, We had an issue where an Engineer setuo his own passwords on our machine, he was then laided off and nobody knew the passwords. Electrovert gave us the following passwords to try: Electrovert Wave Solder Logon Id Supervisor Password Pass
Electronics Forum | Tue Jan 17 08:44:50 EST 2006 | adlsmt
Does anyone know a master user name and password for an Electrovert Vectra?
Electronics Forum | Thu Apr 17 07:47:07 EDT 2014 | emeto
Hello all, does anybody know How to set paralelism on Electrovert OmniFlex 10? I couldn't figure that out on my own, so please help.
Electronics Forum | Thu Mar 01 14:35:52 EST 2012 | edmneb
We recently got a used Electrovert Bravo 8105 in house, but the unit did not come with any passwords to access the software. Any one know a default password, or way to change the passwords? Thanks!
Electronics Forum | Mon Apr 24 14:04:44 EDT 2006 | pjc
You did not tell us where your boards fit on the thermal mass range. That is key. I've run Pb Free low to medium thermal mass boards with good results on a 5 zone oven (5 top/5 bottom). You should not have a problem running a medium thermal mass boa
Electronics Forum | Fri Mar 02 22:36:11 EST 2012 | kahrpr
Its usually Bravo
Electronics Forum | Tue Aug 24 22:32:18 EDT 2004 | pdeuel
We have a Soltec Deltawave with single nozzle spray fluxer, chipwave, and waveform. It preforms well. I am not fimilar with Electrovert models so I can only give you some of the pitch I got when I went back East for training. Features I like about th
| 1 |
.gif)
winsouce.jpg)
