Electronics Forum | Thu Aug 11 10:21:40 EDT 2005 | leonb
HI all, i have 2 omniflow 5 zone reflow ovens would these be suitable for rohs compliance also 2 iemme 760 reflow oven with 4 upper zone and 4 lower zones would these be suitable also any feed back would really help
Electronics Forum | Thu Aug 11 16:20:54 EDT 2005 | pjc
I have seen good results on OmniFlo 5 for Pb Free solderpastes PROVIDED the boards are low to medium thermal mass and have no high conveyor speed (high production) requirements. Max peak temp you can set on O5 is 280C, enough to get 230C on-board tem
Electronics Forum | Mon Apr 29 01:29:29 EDT 2013 | aemery
If your current problem with the conveyor speed was caused by the SMEMA issue, maybe you have a Board #1 problem. The SMEMA communicates to the computer through Board #1. The input signal from the speed encoder and the output analog voltage to the
Electronics Forum | Tue Nov 14 11:43:49 EST 2017 | matthale
Does anyone know of a good servicing company for Omniflow reflow ovens? Preferably in the north of the UK. The chain rails on ours have warped and need straightening. While the oven is still usable without, it is by no means ideal.
Electronics Forum | Wed Nov 15 07:04:11 EST 2017 | spoiltforchoice
Short of the obvious choice of Etek-Europe as the UK representative, not really. They also retain quite a few sales& engineering people form Contax who did it before them. There seems to have quite a collection of small companies in the UK that servi
Electronics Forum | Wed Sep 06 15:27:39 EDT 2006 | Stick
I'll guess 5, maybe 6, but no more than 7. Thanks for the insight
Electronics Forum | Wed Jan 04 08:28:23 EST 2023 | steve1418
i think GX5 better
Electronics Forum | Sat Apr 09 21:44:07 EDT 2005 | Marcel
Go in dos, go in the CONFIG dir. Edit the file ACCES.000 Yours passwords are there. You can delete the file and reboot, that will reset all passwords to factory default Operator MPM1 Maintenance MPM2 Supervisor MPM3 Calibrate MPM4 M
Electronics Forum | Tue Jan 28 10:36:39 EST 2014 | cbeneat
Have you tried 4530, again for the X5's this is our operator password. Good luck
