Electronics Forum | Wed Dec 18 14:48:48 EST 2013 | emeto
Hello all, looking for a solder paste mixer. Capacity is not an issue, but price is. Anything below 500$ will be fine. Any ideas?
Electronics Forum | Tue Dec 08 11:55:28 EST 2009 | GSx
here some of them: http://www.mvent.com.ph/malcom/sps1.htm http://www.bikudo.com/product_search/details/116079/solder_paste_mixer.html http://www.japanunix.co.jp/ju_en/products/UM-103.html http://www.fancort.com/robotic/_solder_paste_mixer.html
Electronics Forum | Tue Dec 08 08:52:42 EST 2009 | cunningham
How do people prepare there solder paste for screen print? We currently remove them from the fridge and mix them in a 500g solder paste tub mixer to mix the flux and paste together we waste to much paste at the moment as we only use the tub for 1
Electronics Forum | Thu Dec 10 12:57:25 EST 2009 | scottp
We've used mostly cartridges for many years and I only saw separation once when a particular paste supplier had a problem. With cartridges it's just thaw and use - no mixing. We have some sites that use jars along with mixers and I've never been co
Electronics Forum | Mon Sep 26 14:07:52 EDT 2005 | jsloot
I am looking for input on a solder paste mixer for 500g jars. Does anyone have a good recommendation? Thanks
Electronics Forum | Fri Sep 30 09:38:08 EDT 2005 | davef
Solder Paste Mixer * Malcom [malcomtech.com] SPS * Japan UNIX [japanunix.co.jp] Uni-Cyclone UM-103 * Genitec [genitec.com] GAM60 * Synergy Engineering [synergymark.com] Unity 500J
Electronics Forum | Wed May 12 08:35:20 EDT 2004 | solderpro
yes this paste is a pain in the paste.... there are very few reasons for solderballs, component to pad ratio and placement.... solder paste control, using a mixer, not hand mixing, checking viscosity and temp..... or simply and bad profile and your
Electronics Forum | Mon Feb 13 12:43:05 EST 2006 | Chunks
Sure, if your solder joints are reliabale after reflow. TZ is right about watching how you mix it, but 9 minutes sounds like it's not moving too fast. What brand of mixer are you using?
Electronics Forum | Mon Jan 15 10:28:49 EST 2007 | Earl Jr.
We use to use a malcom mixer but found it caused problems of solder/flux separation. This may be causing you problems. Earl Jr
Electronics Forum | Sat Apr 19 10:45:43 EDT 2003 | Joe
Yngwie, In a previous life, I used a mixer made by Malcolm and was very happy with it. We used Alpha 609 WS paste and experienced no separation problems. The Malcolm equipment agitated the material in a non-concentric motion which tends to "fold