Electronics Forum | Mon May 25 21:10:28 EDT 2009 | padawanlinuxero
Hello !! I have a problem with my wave solder oven, in one of the products we made has connectors on one side of the pcb and in the other one has SMT components the process is kinda tricky on the SMT components we use an adhesive and put to the refl
Electronics Forum | Wed Jul 08 15:18:20 EDT 1998 | Upinder Singh
We are wave soldering a board having 24 similar thru hole connectors on it, using a wave soldering pallet. The problem is that one particular pin of connector in around 6-9 connectors get excess solder on the bottom side. I have tried all the parame
Electronics Forum | Tue Jan 16 16:59:39 EST 2007 | realchunks
Pallet angle is usually pretty good. Lead length is also another good thing to keep as short as possible. Air Knives don't work that well. Also check your board. Make sure you have solder resist between each and every thru-hole pad. If the board
Electronics Forum | Thu Jul 09 17:12:00 EDT 1998 | Dave F
| We are wave soldering a board having 24 similar thru hole connectors on it, using a wave soldering pallet. The problem is that one particular pin of connector in around 6-9 connectors get excess solder on the bottom side. I have tried all the par
Electronics Forum | Wed Jul 22 15:05:31 EDT 1998 | Dave F
| | | | We are wave soldering a board having 24 similar thru hole connectors on it, using a wave soldering pallet. The problem is that one particular pin of connector in around 6-9 connectors get excess solder on the bottom side. I have tried all
Electronics Forum | Tue Jul 14 15:21:28 EDT 1998 | Brian Conner
| We are wave soldering a board having 24 similar thru hole connectors on it, using a wave soldering pallet. The problem is that one particular pin of connector in around 6-9 connectors get excess solder on the bottom side. I have tried all the par
Electronics Forum | Fri Jul 10 13:58:49 EDT 1998 | Bob Willis
The parameters which effect the problem you are having are flux and contact time try first increasing the flux you are applying. Next reduce the contact time in the wave by adjusting the back flow plate. If the problem is a jig design check out the j
Electronics Forum | Wed Jul 15 15:18:12 EDT 1998 | Upinder Singh
| | We are wave soldering a board having 24 similar thru hole connectors on it, using a wave soldering pallet. The problem is that one particular pin of connector in around 6-9 connectors get excess solder on the bottom side. I have tried all the p
Electronics Forum | Thu Nov 19 10:24:14 EST 1998 | Brian Co nner
Currently, I am having problems with a AMP Mictor connector at the wave process. These connectors have both SMT leads(topside) and thru-hole leads. Even though we have re-designed the board for via issues. We still see some of the SMT leads re-fl
Electronics Forum | Tue Sep 09 09:02:39 EDT 2008 | floydf
We are quoting a job that has about 30 50 pin D connectors on one side of the board, and about 10 on the other side. Barring any stroke of genius, we would wave solder one side, and hand solder the other side. Does anyone have any suggestions on how
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
