Electronics Forum | Fri Sep 13 18:58:12 EDT 2002 | slthomas
I can't give you itemized values for each defect category because we don't ask operators to distinguish between them, and we haven't done any serious research to do so either. I do wonder this, though. I read data somewhere from 14 years ago statin
Electronics Forum | Wed Mar 24 15:04:05 EST 1999 | Greg Curler
I am looking into replacing another business division's Acrylic coating process with our Urethane coating process. Unfortunately, MIL-I-46068 doesn't differentiate AR/UR's performance, and the MFR data sheets don't match up at all (they each spec di
Electronics Forum | Wed Mar 24 21:40:05 EST 1999 | Dave F
| I am looking into replacing another business division's Acrylic coating process with our Urethane coating process. Unfortunately, MIL-I-46068 doesn't differentiate AR/UR's performance, and the MFR data sheets don't match up at all (they each spec
Electronics Forum | Fri Mar 26 13:02:18 EST 1999 | Scott McKee
Sorry, in the following message I'm agreeing with Graham - not Greg... | | I am looking into replacing another business division's Acrylic coating process with our Urethane coating process. Unfortunately, MIL-I-46068 doesn't differentiate AR/UR's p
Electronics Forum | Tue Jun 26 14:54:10 EDT 2018 | etmpalletguy
Be careful, and make sure you ask for proof that the liner your buying is ESD safe! Also, make sure your customer is aware that the liner is made from silicone, in most military & aerospace, no silicone can touch the PC! If your liners are 18x18 and
Electronics Forum | Thu Mar 25 19:19:08 EST 1999 | Graham Naisbitt
| I am looking into replacing another business division's Acrylic coating process with our Urethane coating process. Unfortunately, MIL-I-46068 doesn't differentiate AR/UR's performance, and the MFR data sheets don't match up at all (they each spec
Electronics Forum | Wed Jun 03 01:06:13 EDT 1998 | Mike Moninger
| We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is not al
Electronics Forum | Thu Jun 30 18:31:28 EDT 2005 | KEN
Make sure your RS232 is screwed in and not loose. Verify your PC is not hanging up and locking up the com port (windows can really suck some times). I would scan-disk and defrag. I bet its not a furnace problem, but a PC problem.
Electronics Forum | Tue Sep 18 07:24:55 EDT 2007 | hussman
Is there a guideline for the manufacturing of PC Boards? I find that my board changes dramatically from board house to board house, causing about 2% failure rate.
Electronics Forum | Tue Sep 18 07:25:32 EDT 2007 | hussman
Is there a guideline for the manufacturing of PC Boards? I find that my board changes dramatically from board house to board house, causing about 2% failure rate.
