Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Tue Feb 23 12:56:03 EST 2010 | vleasher
Is there any harm in washing SMT soldered with NoClean paste? The PCA has some large thru-hole connectors that we would prefer to do as water soluble on out selective solder but the SMT consists of LGA's and other low parts that we would not be able
Electronics Forum | Thu Sep 27 17:25:33 EDT 2007 | chef
The short answer is immediately after reflow the problem occurs. To be more exact, what you are describing is not "rust". Rust occurs in iron. The oxidation that occurs in Tin-Lead has been sometimes called "white rust". Either way, oxidation occur
Electronics Forum | Wed Aug 23 08:50:04 EDT 2000 | Dave F
Dr. Lee: We had a discussion on the forum recently and I wanted to get your input. What is the best method(s) for elimating (reducing) no-clean solder paste flux from splattering on gold interconnect fingers on a PCA?
Electronics Forum | Wed Jul 12 16:33:39 EDT 2000 | Mark Charlton
We just went through a difficult time processing SMT immersion white tins PCA's and found the following: 1. FAB vendor had a degraded tin solution resulting in improper plating thickness 2. FAB vendor was not using the proper cleaning process Get
Electronics Forum | Mon Mar 25 13:48:52 EST 2002 | bcceng
We are currently applying solder bumps to hundreds of BCC's for rework. It is impossible to print to the PWB. It is recommended to apply solder bumps to the BCC's with 63/37 alloy making the rework faster and easier. Applying the solder bump on the
Electronics Forum | Fri Sep 07 15:19:42 EDT 2001 | davef
Watt tiepoo? [Cereally, you can usually fix typos after you post by using the P yellow �edit� button that shows when you are looking at your posting.] We�re had people on SMTnet that were washing their boards with a brush attached to the end of a ga
Electronics Forum | Mon Feb 14 21:28:22 EST 2000 | Dave F
Tobacco smoke is made up of "sidestream smoke" from the burning tip of the cigarette and "mainstream smoke" from the filter or mouth end. Tobacco smoke contains thousands of different chemicals which are released into the air as particles and gases.
1 |