Electronics Forum | Mon Jun 06 11:56:45 EDT 2005 | ratsalad
Thanks for the leads. They both said they might have one and they are checking into it. I was right the first time! All three cameras are the same. It was the Panasonic help desk that told me they were not. Checking in the manual shows all three
Electronics Forum | Thu Jun 09 07:36:49 EDT 2005 | ajaydoshi
Thanks, 1. Any idea how to go about pallet. because this PCB is single only ( not in multiple ). if you have some drawing / picture pl. send me at ajay_doshi@utlindia.com 2. What are other parameter to set on machine ajay
Electronics Forum | Thu Jun 09 16:13:24 EDT 2005 | PCBER
Hi, I am having trouble finding PCB material per IPC4104/21, Type L210938C2/C2BA. Can somebody please suggest me who might can supply this? Thanks in advance Regards, PCBER
Electronics Forum | Wed Jun 15 10:42:52 EDT 2005 | Steve
There used to be a product simply called bean bags that you put on a pcb to keep components from lifting up during the wavesolder process. Any one know where I might find this product?
Electronics Forum | Wed Jun 22 08:13:28 EDT 2005 | davef
Use an epoxy to repair the solder mask. Sources are: * http://www.circuittechctr.com/index.shtml * http://www.engineeringlab.com/baseboard.html
Electronics Forum | Thu Jun 23 21:04:04 EDT 2005 | darby
If you have concluded that it is not a file storage problem you may wish to consider - When setting up a job the camera can move to virtually any position. This does not mean that the actuators on the stencil or board have enough travel to align the
Electronics Forum | Sun Jun 26 12:03:38 EDT 2005 | geb
Re: 23-Jun-05 16:09 (pr) It is a pad, cos the fids on the PCB are in a different place to the ones on the stencil.
Electronics Forum | Thu Jun 23 09:33:02 EDT 2005 | jdumont
Hi all, we will be moving our pcb production to a different (newer) part of the plant this summer in an effort to reduce dust and better control the temp/humidity. What can I install to keep the dust down? Are there air exchangers/filters for a room
Electronics Forum | Thu Jun 23 22:30:31 EDT 2005 | wjxingggg
poor soldering of PCB. > unfit stencil hole of QFN > incoming problem for this component >...... What is your opinion? or what can I do for the next step? Thanks again.
Electronics Forum | Fri Jul 08 09:14:49 EDT 2005 | Jason Fullerton
I've tested boards with SN100C HAL finish, and wetting to the PCB finish was poor at best, using a no clean SAC305 paste.
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, CA USA
Phone: 5102268155