Electronics Forum | Wed Sep 24 11:43:15 EDT 2008 | pgarsoe
I'm not sure this would solve your problem but Inovaxe has done a good job of solving MSD and inventory handling and control. They are also a sponsor of SMTnet...here is their SMTnet listing followed by thier web site for their carts... http://www.sm
Electronics Forum | Tue Aug 12 15:34:37 EDT 2008 | grics
That is very interesting... I am curious though, why wasn't a plain blind rivet used? You probably can, but personally, I would be not want a solder joint holding the frame and the pcb... Mechanical stress on solder joints often leads to not good re
Electronics Forum | Tue Aug 12 14:49:26 EDT 2008 | awegener
I'm attempting to pick and place a small rivet onto our PCB. The rivet should be attached via reflow solder. The rivet will be used to create a sandwich, holding together a frame and additional circuit board in a package. This part is intended onl
Electronics Forum | Mon Aug 18 15:03:38 EDT 2008 | awegener
I'd like to get more information about pick and place nozzles. How can I learn more? ... What do the nozzles look like? Are there different shapes? Are custom nozzles sometimes used for custom parts or are the nozzles mostly standardized? What kind
Electronics Forum | Wed Aug 13 05:18:40 EDT 2008 | lococost
that's a pretty cool idea, I like some thinking 'outside the box '! 1. I don't think picking it up and placing it will be much of a problem. once the rivet is placed it will be held in place by the paste. However, you would need to make a tray that
Electronics Forum | Fri Apr 20 07:30:14 EDT 2001 | wbu
In short: the measured deviation / the length this deviation occurs * 100% = % of deviation Actually we encounter mostly "twist" so we put the board on a flat surface, hold it down at the corners to see if any of the corners lifts, measure the heig
Electronics Forum | Mon May 14 09:35:21 EDT 2018 | directx995
Hello everyone, A few days ago I design one special kind of PCB for testing accuracy of our Pick and Place machines. (for trimming, calibrating, NPI etc.) I am looking for adhesive spray, to apply it on PCB (at the moment I'm using double sided tape
Electronics Forum | Sun Jan 13 19:44:02 EST 2008 | grantp
Hi, We need to solder a USB plug onto a PCB in our SMT machines, and this is the same type of plug you see on USB storage devices. It's a very flat connector with 4 SMT pins, however the hard part is the bottom of the connectors is the same level
Electronics Forum | Wed Jan 16 04:16:11 EST 2008 | grantp
Hi, That's great, and I did not know this was possible, as I did not see that thread when I searched the archives. Do you know of any companies that take your board outline and will design a palette to hold it through the printing, smt loading and
Electronics Forum | Fri Oct 22 11:53:53 EDT 2004 | C Lampron
Hi Christina, What would you be basing the yields off of? Is it solder defect, component placement, etc....? I have worked for a flex house for quite a few years. You are right. The Polyimide is very dimentionally unstable. (even more so on humid da
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
