Electronics Forum | Mon Oct 14 18:27:38 EDT 2002 | kennyg
In regards to baking an assembly prior to hot air (BGA) rework.... 1) Do people always bake, sometimes or never? Does this depend on whether MS sensitive components are near the rework site? If a BGA is to be removed and reballed, baking is a no-br
Electronics Forum | Tue Oct 15 10:12:44 EDT 2002 | davef
1) Do people always bake, sometimes or never? Does this depend on whether MS sensitive components are near the rework site? If a BGA is to be removed and reballed, baking is a no-brainer. Sometimes, based on the proximity of the MS components. >2)
Electronics Forum | Tue Jul 16 00:53:39 EDT 2002 | kennyg
What is a typical time/temp baking cycle for an assembly prior to BGA rework? This bake is intended to prohibit PCB or nearby component damage as well as protect the component being removed for reball. A 24 hr bake at 125C would be great, but often
Electronics Forum | Tue Jul 16 01:12:31 EDT 2002 | ppcbs
We find that baking PCB assemblies at 90 degrees C in a Blue M forced air oven is safe for most all PCB's that we have encountered over the past 12 years. We remove any external plactic hardware that may be attached to the assembly and also like to
Electronics Forum | Wed Jul 17 11:45:48 EDT 2002 | fmonette
The current IPC/JEDEC standard J-STD-033 for moisture-sensitive devices does not include a bake cycle at 90C (it includes cycles at 40C and 125C for non-assembled components in reels or trays). However, the upcoming revision, which should be release
Electronics Forum | Fri Oct 04 11:34:42 EDT 2002 | Bob Willis
Some additional comments from a paper may be of interest. Baking Printed Circuit Boards - Why and How Baking printed boards prior to conventional and surface mount assembly should not be necessary. Often boards are baked for historical reasons; in
Electronics Forum | Mon Aug 01 18:50:46 EDT 2005 | crishan
Hi Cecil, We using conformal coating in our manufacturing area, we did use to use Humiseal, others have been Bectron and Peters. We recentalt switched all lacquering to Peters, since it is lead free and it is a lot friendly than Humiseal. To answer
Electronics Forum | Tue Nov 19 02:59:24 EST 2002 | yngwie
Hi Experts out there, pls help me with the following matters. How important is the bare PCB baking ? What is the temperature for baking @ what RH ? What would be the impact for the ENTEK finished board should the baking is really necessary ? For t
Electronics Forum | Wed Nov 20 16:53:18 EST 2002 | davef
Q1: How important is the bare PCB baking ? A1: Baking boards is a non-value added activity. Q2: What is the temperature for baking @ what RH ? A2: Search the fine SMTnet Arcives for bake recipes. Q3: What would be the impact for the ENTEK finishe
Electronics Forum | Wed Mar 29 04:14:49 EST 2000 | Marc
Charlie B: You mentioned that you have an air conditioned environment and a RH 0rf 50, baking the boards is predominately done when the history of the PCB delivery and / or previous storage conditions are un known. When I was with a CM, we did this a
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
