Electronics Forum | Tue Jul 16 00:53:39 EDT 2002 | kennyg
What is a typical time/temp baking cycle for an assembly prior to BGA rework? This bake is intended to prohibit PCB or nearby component damage as well as protect the component being removed for reball. A 24 hr bake at 125C would be great, but often
Electronics Forum | Fri Oct 04 11:34:42 EDT 2002 | Bob Willis
Some additional comments from a paper may be of interest. Baking Printed Circuit Boards - Why and How Baking printed boards prior to conventional and surface mount assembly should not be necessary. Often boards are baked for historical reasons; in
Electronics Forum | Fri Nov 22 10:38:30 EST 2002 | slthomas
The follwing is from the Technet archives, per IPC's Jack Crawford. I dug it up during some investigation of a supplier's issues with humidity in an Asian plant: There is support for this in IPD-HDBK-001 w/Amendment 1 Handbook and Guide to Suppleme
Electronics Forum | Wed Mar 23 10:16:47 EDT 2011 | blnorman
If these are moisture sensitive they are required to be shipped in a moisture barrier bag and labeled as moisture sensitive. Depending on which moisture sensitivity level (MSL) the components have, floor life can range from unlimited to a mandatory
Electronics Forum | Tue Sep 03 18:14:35 EDT 2002 | fmonette
I have never heard about a requirement for temperature ramp-up for baking components at 125C. In general the concern for delamination with moisture sensitive components starts above 200C (peak body temp). Most important is you should bake your com
Electronics Forum | Wed Jul 28 20:28:26 EDT 1999 | Carlos Palacios
Currently, we are baking any PCB before process on SMT, the 'reason' is to dry any possible humidity that could be inner the PCB, it does not matter if the PCB is multilayer or not. We bake PCB's at 107C for 4 hrs and the board must be process into n
Electronics Forum | Mon Jan 17 17:20:40 EST 2011 | dyoungquist
The cut can be as close to the component as you want as long as you do not damage the component or any surface mount pads/traces/through holes/internal pcb planes etc.
Electronics Forum | Tue Jan 25 21:35:26 EST 2011 | rway
It seems 1/16" has been speced (component to pcb edge). This is our spec and we conform to IPC, but I am not completely sure if this is what IPC std states. Does anyone else know if this is in deed the true spec?
Electronics Forum | Thu Aug 09 09:05:09 EDT 2007 | davef
There are no requirements acceptance criteria for baking of board assemblies. What are your customer requirements? The common reasons people choose to bake PCB are to prevent: * Delamination of multilayer boards * Measles, particularly on double si
Electronics Forum | Thu Aug 16 13:00:32 EDT 2007 | russ
Here is what you need to do if you can, Since you want to shporten the bake time you need to increase temp. weigh a board prior to your current bake process (you need very hi resolution scale for this) weigh the same board after current process a
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)