Electronics Forum | Mon Nov 02 22:02:01 EST 2009 | boardhouse
Umar - the boards are not assembled - so Solder splash is not applicable. Solder resist does not Melt it cures. As a board supplier I would not want my clients to adapt if they are receiving crap product, I would expect them to leave.
Electronics Forum | Sun Nov 01 23:51:44 EST 2009 | boardhouse
Hi Julie, My opinion is that the top board would not pass IPC, solder mask encroachment on pads. Second board is what we call Orange peel,this can be caused two way's. 1) the solder mask was not tack dried enough prior to imaging which caused artwo
Electronics Forum | Mon Nov 02 07:16:47 EST 2009 | umar
Base on the top picture condition, seems like the boards condition is a lot with solder splash or solder ball which is per IPC-610 is under reject (under 5.6.2)for class 3 product. While the picture 2 is showing those the solder resist is not melt pr
Electronics Forum | Mon Feb 04 20:27:25 EST 2002 | davef
1,000 G ohm ||100 M ohm Dielectric Constant ||9.5 ||4.9 Loss Factor ||5 - 20 ||200 * E indicates exponent Continuing: * Spacing between same plane traces effect the electical parameters between the traces. * Dielectric materials used between diff
Electronics Forum | Thu Nov 11 09:29:54 EST 2004 | rlackey
Wow, it's amazing what you can achieve with smoke & mirrors! Only joking. Does the original via hole covering solder get put on at the PCB fabrication plant, or by the customer? & Does the entire board get reflowed or do you have a process where ho
Electronics Forum | Wed Dec 08 09:53:23 EST 2010 | fönsi
Hello Because of the cold weather, we had some troubles with drying out of printed solder paste on the pcb's. The relative humidity in the air declined below of 20%. We have a process window of store the printed board for maximum 24 hours, but with
Electronics Forum | Mon Jun 21 11:14:25 EDT 2004 | exmaintenanceleader
Dear Kanwaljit Singh, my opinion is following: 1)solderpaste type is ok - usual (alpha-metals has this problem inside the paste paste- holder problem) - what do the operator when production change -clean well the stencil holes!! no visible rest on
Electronics Forum | Wed Jan 06 01:43:27 EST 2010 | oddbudman
Hello, we have recently had some products returned (they were installed and operating in the field for around 2 months before they were returned). After looking at the boards it seems the vias have failed. We now have 2 pc pcbs with the same Via fa
Electronics Forum | Sat Jun 12 00:34:00 EDT 2004 | kanwal324
Hi ! The main problem being faced currently is formation of solder balls - to be precise, these are micro solder beads generally found attached with bodies of SOTs, Chip Caps, Chip Resistors, between pins of SOICs (50 mil) - lying on PCB surface,
Electronics Forum | Thu May 07 08:11:58 EDT 2009 | davef
We don't have a good answer for you, but we do have several thoughts on the issue: * First, tin in your solder or solderability protection is going to diffuse into the copper trace or pad on the board naturally. You can stop that by using a protectiv
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
