Electronics Forum | Fri Jul 13 08:54:18 EDT 2007 | rgduval
Has your board house reviewed the PCB layer stack? Make sure that the layers are balanced in copper weight, etc? Have you tried pre-baking the boards? We just had an issue with some boards warping that have never warped before for us. It happened
Electronics Forum | Tue Jul 07 07:44:23 EDT 1998 | Wayne
| Hey Dave... I agree with Steve, get them dry. Even though you are using DI water, once exposed to normal atmoshere the DI residue water will become contaminated. Fungus and board failure down the road. Not to mention if you plug it into test an
Electronics Forum | Sat Feb 15 06:40:14 EST 2003 | Hans Koerner, Germany
It is a serius problem with that mulilayer ceramic caps! In automotive applications you have to use 2 in series for one single cap. During depanelizing you create a mechanically wave in the board, so 3.. 4 mm. Best way is not to do such a wrong desig
Electronics Forum | Mon Aug 27 04:13:49 EDT 2012 | thmeier
Moisture should not be an issue with ceramics, but mechanical or thermal stress definitely is. Has there been rework on this capacitors? So check for handling /temperature of your soldering irons (better:use hot air). Check oven temperature/profile
Electronics Forum | Fri Feb 18 09:41:44 EST 2000 | James Lewis
Has anyone seen or put together a good collection of proper handling procedures for components and PCB's? I realize a lot of it is no-brainer stuff, but I need some depth for a training class we are putting together. This would include ESD, Moisture
Electronics Forum | Fri Feb 18 09:41:44 EST 2000 | James Lewis
Has anyone seen or put together a good collection of proper handling procedures for components and PCB's? I realize a lot of it is no-brainer stuff, but I need some depth for a training class we are putting together. This would include ESD, Moisture
Electronics Forum | Tue Jan 08 11:28:30 EST 2002 | mregalia
We use NC flux exclusively for SMT and wave soldering. And it is a fairly old formula from Multicore, though we are currently qualifying a new formula. The automated soldering does not appear to be a problem. It is only the hand soldering that causes
Electronics Forum | Wed Jun 24 23:52:41 EDT 1998 | Phillip Hunter
| Has anyone seen a problem with solder under chip components, in-between the glue and the component or in-between the mask and the component? We seen both. | What could be causing this? This has only been detected on one of our products. All the re
Electronics Forum | Fri Aug 07 01:02:51 EDT 1998 | zeek - just wanna to get a word in here
| | I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and t
Electronics Forum | Fri Nov 11 22:14:11 EST 2022 | kumarb
I would certainly test the boards but from our experience, the vacuum sealed in room temp, no issues at all with our PCBs sourced from Suntak / PCB Founder / Fastprint / Yaxinda / JLCPCB well past the 12 month mark. We building boards purchased 5-10
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
