Electronics Forum | Fri Nov 24 11:21:06 EST 2000 | Ramon I Garcia C
HI GUYS: COULD SOMEBODY ELSE SAID ME WHERE TEST THE CONTAMINATION IN BOARDS,NOW I HAVE A PROBLEM WITH SOLDER WAVE PROCESS,THERE ISN�T FLOW ON THRU HOLE. AND I THINK MAYBE IS CONTAMINATION IN PCB. THANKS. RAMON I
Electronics Forum | Tue Jun 08 09:37:20 EDT 1999 | Rob C
Anyone know a independent PCB inspection of BGA (X-Ray). We have several test boards that need BGA inspection.
Electronics Forum | Thu Oct 26 13:56:08 EDT 2000 | ptvianc
Hello: Pre-baking laminates should only be performed:(1) to meet contractual agreements or (2) in response to an actual defect that can be traced to PWB water absortion. Besides the fact that a pre-bake is an enormous process "bottleneck," it also
Electronics Forum | Wed Nov 09 02:24:49 EST 2005 | laxman
Hi Dave, Normally in our country (India) during rainy season the temperature will be 25to 30 �C and RH of 50 to 60%. The reason behind this humidity issue is that recently we have moved to our new facility with centralised air conditioner with Chill
Electronics Forum | Fri Jan 30 10:29:48 EST 2009 | petep
We have a potential new customer who has special PCB requirements. I do not know a lot of details at this point, but have several questions. One of their assemblies has within it , a MID, Solid foil layer, completely isolating one side of the PCB f
Electronics Forum | Fri Oct 14 13:12:30 EDT 2005 | Mika
Thanks Patrick, I our mixed standard HASL/RoHS production area; our customer have choosen Ni/Au plating for their RoHS boards. What You are saying (3.); is that we should be more attentive on the quality of the pcb manufactory. Even if our customer
Electronics Forum | Mon Dec 21 12:20:52 EST 2009 | MLD
Here is my question to the Guru's on this site. Lead free boards to go though Wave / reflow - and then sent through a water wash 2 day's prior to Hand assembling a 50mil ribbon connector. This is a 4 layer board with 2x2116 pre-preg (.036 1/1 5x762
Electronics Forum | Fri Apr 10 18:51:39 EDT 2009 | boardhouse
Hi Jeff, Your board supplier could be correct in this way. The board could have had just a hair left of copper on the circuit, which would hold up under the electrical test process, but once you powered it up, then there was enough juice to burn th
Electronics Forum | Wed Apr 02 23:02:38 EST 2003 | scottf
I agree with Iman. Verify the integrity of the component for moisture. Most definately place an amount of ownership on your PCB supplier. Request tank analysis results and copies of the lot travelers. Look specifically for any in process rework pro
Electronics Forum | Fri Sep 19 11:39:38 EDT 2003 | joeherz
We have recently started building a new assembly that is exhibiting some strange behavior. We are seeing what look like blow holes in wave soldered joints. When the joints are touched up, the solder in the barrel will actually bubble up from the ho
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830