Electronics Forum | Tue Aug 14 13:54:57 EDT 2018 | etmpalletguy
Vlad, Reduce your aperture opening in the stencil, this will give the stencil a good seal around the specific area of concern. In a wave solder environment, solder balling top or bottom surfaces in a wave pallet is caused by excessive flux burning o
Electronics Forum | Tue May 26 11:13:49 EDT 2009 | xinxi
Is the components on the top or on the bottom of the pcb? Have you checked whether the temperature on pcb are too high when it pass through SW that it exceeds the limit that the components can take? Do check with the component manufacture for the te
Electronics Forum | Tue Apr 28 16:20:06 EDT 2015 | warwolf
Is this solder lead or lead free? Try look at the delta of the PCB during re-flow, you might find that the smaller parts are being "cooked" faster and burning off the flux.
Electronics Forum | Thu Nov 10 13:55:25 EST 2005 | 1st Article
Milroy, Another thing to look at is your wave profile. Check speed and pre-heat, if flux gets burned off before reaching the wave then bridging is expected, a common way to check for speed is to time the point of first contact through the sub-merge
Electronics Forum | Tue May 02 13:07:55 EDT 2006 | Jbrower
Howdy all. The question that I have is on wave solder pallets. I'm getting quite a bit of flux trapped on the pcb where it contacts the wave solder pallet. I have an appropriate profile for my assemblies, The flux that i use is Kester 920-CXF No Cl
Electronics Forum | Tue May 02 12:17:22 EDT 2000 | C.K.
Donnie is correct. "NO-Clean" doesn't translate to "no-residue!"..... who's giving you hassle about this - your ICT guys??!! Residue remaining on your PCB substrate is a function of many different things - flux deposition, solder mask (glossy means
Electronics Forum | Wed Nov 28 09:17:17 EST 2001 | Dave G
I've heard of reliabilty problems caused by wave soldering melf's as well. We don't put Melfs on the bottom of our PCB's on newer designs. We only have to deal with gluing & putting them through the wave on some of our older legacy designs. Increasi
Electronics Forum | Mon Mar 02 13:06:36 EST 2020 | charliedci
If you add any "flux cored" wire solder to the pot make sure you have ventilation as the flux will burn off and smoke like crazy. This solder pot is like any used in a wave or selective solder, no flux. The flux is added to wire prior to di
Electronics Forum | Tue Dec 29 04:27:08 EST 1998 | John W
| I have an inbteresting problem on my N2 wave soldering lines. | We have two N2 wave soldering line. Line A is old one and Line B is new. | We found solder balling Phenomenon on PCB After soldering in the new N2 Atmosphere Wave Soldering Machine. In
Electronics Forum | Tue Sep 25 14:38:05 EDT 2001 | nwyatt
1. SRT has been recently calibrated - problem is too many hands in the machine and careless mistakes. The profile is good and has been recently checked by a fellow from Genrad. 2. We are relying on the left over solder from the previous joint and
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)
