Electronics Forum | Thu Jan 07 03:32:19 EST 2021 | ravikumargv
Dear All, In S27HM siplace machine PCB camera images not display and when i try to teach feeder potion or fiducial position PCB camera light is glowing but, images not showing in monitor, kindly help what is the root cause for this issues... Regard
Electronics Forum | Sat Jan 09 20:00:04 EST 2021 | oxygensmd
I had similar issue on S20 two times. The portal2/gantry2 have camera image? Have working camera system - if other camera ok, PCB camera will be the problem. Have camera screen on BE/Components camera? Have iCOS PC working. - Check the camera conn
Electronics Forum | Thu Jan 07 03:34:24 EST 2021 | ravikumargv
Attached Image FYR....
Electronics Forum | Mon Feb 25 09:22:02 EST 2019 | robertorocco
When the pcb is inserted into printer, the camera moves from the origin to the stop pcb, after a few seconds the message "axis camera error" "out of time" appears. In the next few days I make a video of the operations done and the error that appears
Electronics Forum | Mon Jan 11 17:19:31 EST 2021 | rmitchell
Problem resolved- The machine camera had crashed when the operator put the PCB in upside down (this was kept secret until intense water boarding). The crash seem to take out a chip on the vision processing PCB. It was visually damaged and looked lik
Electronics Forum | Fri Apr 04 21:16:56 EDT 2014 | padawanlinuxero
Same option is in the MV-2 Open both programs and then run one of them after inspection turn the board and press start it would change to the other program with no problem.
Electronics Forum | Sat Mar 29 10:04:03 EDT 2014 | josse
Hello there everyone! Our company just bought an AOI Inspection Machine, and that is the Mirtec MV-2HTL 1.3 megapixel, software rev 4. I am trying to create a program that runs the top side first and then asks to run the bottom side consecutively. I
Electronics Forum | Tue Apr 01 16:14:37 EDT 2014 | emeto
Hello, I have newer generation machine(MV-7) and in my software I can open two programs at the same time. After you do that there is a button in the software saying T/B. when you press this button it will run board1(or top side) and right after you
Electronics Forum | Mon Jun 06 10:43:23 EDT 2005 | ratsalad
Hello there, We have a Panasonic MVIIC with a bad PCB camera. The amp is fine, we tested that by swapping it with the small and large parts camera. When the machine is shut down for a while and we bring it back up, it takes hours for the PCB camer
Electronics Forum | Mon Sep 21 22:56:19 EDT 2009 | edison
Hello, everyone. Does anyone know the exact difference of SIEMENS SIPLACE PCB-optical System KST PCB camera between P/N 00344065-03 and P/N 00344065S03? Thank you for your reply in advance.
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
